TV Repair: Common Faults and Solutions.
Search:
Results: 87418
Results: 87418
Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
SONY | WMD6C | Motor does not turn | The customer told me that he plugged in 12vdc instead of 6v.the amplifier section was fine, but the motor did not turn. | ||
SONY | CFS300 | Part number incorrect - ic3 | On page 18 and again on page 20, ic3 is stated to be a la4126.on page 29 of the parts list, it is a la4125t. which is correct? theseare not listed in the handbook as being interchangeable. -hq comments: the correct part is la4125t. part # is 8-759-80 | ||
SONY | CCDV8 | Tape jam | Tape broken and wrapped around top of drum assembly. | ||
SONY | TCFX510R | Replacement of panel and buttons for rec and rec mute | Servicer would like to replace panel and buttons for rec andrec mute however, these buttons are not shown separately on page 35 ofs/m. can we get these or do we have to replace entire front panel assy? -hq comments: the rec and rec mute buttons are par | ||
SONY | BMC110 | Units dead | Units doa. after making basic tests, found pin 38 (reset)held at 205 volts. syscon ic301 not able to reset. located leaky capaci-tor c341. | ||
SONY | XR70 | Noise on the outputs in tape mode | Every xr-70 i have worked on has a motor noise in tape modethat is noticeable at low or no volume. -hq comments: head amp may be picking up motor noise as they are locatedclose to each other. try a shield around the motor. | ||
SONY | TCFX1010 | Communication with asp chip | Always in muted mode. tape plays, meters correct. in recordmode there is no control of level (rec) even though the attenuator reads-70db. ic710/703/704/309 replaced. all power supplies were within 0.3v. | ||
SONY | WM10RV | No auto stop | The unit did not stop or switch the direction automatically. | ||
SONY | WA16 | The unit changes direction fwd/rvs by itself | The unit changed the direction rwd/rvs by itself. alsonoticed the take-up and the supply reel did not turn. | ||
SONY | RS20 | No outgoing message | When we try to record the outgoing message, it rewindsadvances 33 reel count and seems to record the message. however, when wepush the in/out switch to out in order to monitor the recorded message,the unit makes the error beep. | ||
SONY | WA11 | No audio | There was no audio coming out from the speaker. | ||
SONY | RT44 | No play | The unit did not play tapes. the take-up reel did not turnand the head base did not go up. | ||
SONY | SRF5 | P/n for wrist strap | Wrist strap is listed as an accessory, but no part number isgiven in manual. -hq comments: the wrist strap is a part of the radio holder assy byp/n x-3892-102-0. | ||
SONY | CCDV8 | Flashing color stripes across the screen | Playback ok. recording defective, poor solder connection onic104 on vi-6 board. | ||
SONY | D5 | Dead | Unit came in dead. voltage out of the regulator read 5.2v.replacing ic802 brought it down to 4.8v. still had problem. when play ispressed, pin 45 goes high (ic801) but pin 2 does not go low, which isshould. | ||
SONY | CCDV8 | Tape jammed | Tape jammed. | ||
SONY | ICFC30W | Radio intermittently goes into sleep mode | After unit has been plugged into ac outlet for 5-10 minutes,unit intermittently goes into and out of sleep mode. | ||
SONY | SLHF500 | Bar in picture | When put in play pause mode, unit would automatically to go rewind function. also, there is a bar that floats through the video from bottom to top. | ||
SONY | KV2680R | No functions when hot, replaced leaky d-041 on "x" board | After turn on, all remote control functions were inoperative,plus manual controls. also the problem would occur about 2 min afterturn on. heat and cold had no bearing on this unit. | ||
SONY | KV2681 | No picture or sound | No picture or sound. |