TV Repair: Common Faults and Solutions.
Search:
Results: 87415
Results: 87415
Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
SONY | KV2647R | Picture draw up and v jitter, c508 reversed | Picture would draw up from the bottom and vertical jitter. | ||
SONY | KV2647R | Set on/off repeatedly, open r-143 | When ac cord is plugged in, the unit turns itself on and offrepeatedly. if the plug to socket labelled mf-5 was disconnected, theset stayed on and would not turn off at all. with this connector removed,there was no dc voltage at pin 21 of ic101 and yet | ||
SONY | KV2145R | Shut down, leaky q881 | Set would shut off once or twice a week. problem wasisolated to hi-voltage shut down crt. found q881 leaky. with a newtransistor shut down voltage increased by 112v, changed dividerresistor for correct voltage. | ||
SONY | KV1948R | Color distortion, color killer adj | While watching old b/w movies, the customer is unhappy withcolor confetti which flashes through picture. -hq comments: we were able to eliminate color confetti problem in ourlab set (kv1547r) by adjusting color killer level using the followingvoltage di | ||
SONY | KV1946R | Incorrect tuning operation, open l508 | Tuning ok, but would not hold channels in memory. | ||
SONY | KV1923 | Sound distortion, replaced ic cx760 | Sound becomes garbled as volume is increased. | ||
SONY | KV1914 | Color distortion | New picture tube would go soft on one of the colors - firstwas the red, second time the blue. found filament voltage from theflyback incorrect. peak to peak was 30v s/b 22, also ringing. | ||
SONY | KV1913 | Incorrect color | Incorrect color phasing. fsc had replaced crt (becausepicture was dark) with new crt installed the screen controls did notaffect the proper color stripe on the trinitron-red controlled green-green controlled blue and blue controlled red. with nysc colo | ||
SONY | KV1747R | Incorrect tuning function | No vhf channels, only snow. uhf channels ok. | ||
SONY | KV1715R | No picture | Intermittently this unit would lose video and the raster wouldget very bright, with retrace lines. | ||
SONY | KV1541R | Vertical roll and foldover, replaced c574 and q551 | Vertical roll and fold over problem. | ||
SONY | KV1513 | Shut down | Horizontal shut-down after unit is turned on. | ||
SONY | KV1217 | Shut down, cleaned and adjusted hor. freq. control | Set going into hv shut down intermittently when turned on.set would also horizontal freq. adjustment was on very edge of locking. | ||
SONY | KP7225 | Dead, yoke connector loose caused other parts to fail | Initial problem - dead. replaced ic301 and q202 on a boardplus f602, 1.6a fuse on board. this restored sound and hi voltage.crt's were blanked out. further examination disclosed q601, regulatordriver, q609, regulator, r609 150Ω at 1/8w open which d | ||
SONY | VTX1000R | Ch 14 would not lock | Cable ch. 14 could not lock in on a cable co. using hrc cablesystem. aft is not pulling far enough down to lock on ch. 14. | ||
SONY | VTX1000R | Tuning would not lock | At turn on, unit would display random channels, never the lastchannel which was displayed at turn off. inspection of circuit revealedno reset pulse at pin 7 of ic001 on a board. this pulse is supplied fromic002. voltage check on ic002 showed only abou | ||
SONY | TV790 | Shut down | Picture takes 5 to 10 minutes to come on and sometimes goesoff after on. found osc. signal at drive transformer weak if probe istouched anywhere before h. drive transistor picture comes on. found e-bjunction of q502 open when transistor cold. | ||
SONY | TV770 | Battery pack availability | Have been contacted by two customers regarding replacementbatteries for eveready type 563. they both stated they contactedeveready distributors for a replacement and were informed that type 563is no longer available and that there is no substitute. hav | ||
SONY | KV9200 | Incorrect brightness operation | Right side of the screen is brighter than left. | ||
SONY | KV9200 | Part mismount | On printed circuit board w, capacitor c524, the marks forpositive and negative connection are incorrectly placed. |