Aiwa TV Repair: Common Faults and Solutions.
Search: Aiwa
Results: 309
Results: 309
Aiwa Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
AIWA | AR295 | Reduced frame horizontally and vertically | Capacitor 407 de 13pf 1k6 v | gomes | |
AIWA | CX-NSZ 11LH | Doesn't start | Remove smd transistor q 130 | juci | |
AIWA | NSX 999 | Nao fucina fm.am | Resolder ci 720, peripheral capacitors, change x721 crystal (change without testing) | eletronica mendes | |
AIWA | NSX-SZ6 --- | Display off | Capacitor co25 -c26 of 47x50v-co50-c51 of 100x50 in a power supply of -46v | Replace without testing | ALPHA ELETRONICA |
AIWA | NSX-SZ6 --- | Turns off display when pressing power (triggers protection) | R115-116-131-132 of 1r on the emitter of q115 and q116 changed | Replace them all | ALPHA ELETRONICA |
AIWA | AR295 | Does not oscillate normally low voltage in the secondary power supply +b with less than 80 volts | C826 100uf / 160v internal terminal with bad contact | Replacing it solved the problem | washington de sousa |
AIWA | TV-AR295 D | Does not turn on sequential noise on the flyback | C826 sold out | Replacelo | eletronicatual (nene) |
AIWA | NSX-F969 | Hits the relay and turns off the sound and remains on, but without the balances on the display | Replace q601 with tip32 | Replace q601 with tip32 | ADEMAR |
AIWA | NSX-S201 | Turns on, has all the functions but no sound. | Resistor 470r position r151 open. it powers the ic601 Audio modulator. | Note: some devices come from the factory with black glue covering the position of the resistor, making it difficult to locate. | ELETRONICA SÃO FRANCISCO This email address is being protected from spambots. You need JavaScript enabled to view it. |
AIWA | CX-NMT70 | Turn on and off | Changing the transistor position q110 (smd) it measures good but is defective bc846 | simas433 | |
AIWA | XH-A 1060 | No sound and CD and tape mechanics inoperative | Without the 12v cold output on the fet on the sound card | carlos jpramos | |
AIWA | JAX-PK33 | Device works, has no display | R908 open on transformer board | predador403 | |
AIWA | JAX-PK33 | Device works, has no display | R908 open | predador403 | |
AIWA | CX-NS305-LH NSX-S305 | Turns on at the same time comes back stand-bye | Transistor output short sound, q214-b1626, q212-d2495, was replaced and the same thing happens. | Replace sound outputs, and see tsound the transformer has a plate with a resistor type (pr005) it is open, put resistor 1r, putting vo, it works | This email address is being protected from spambots. You need JavaScript enabled to view it. |
AIWA | NSX-SZ21 | Doesn't read cd | Unit not found ksm-880 replace with sf-p101 not with kss213 keeps failing | Paulo.nickel | |
SOM AIWA | TODOS | Optical unit skipping skipping tracks | Defect in the unit cart motor, | Replace the engine. obs. To avoid warranty problems, replace the optical unit, preferably the original, good luck, professional friends. | fernando timbauba PE |
AIWA | AR295 | Does not turn on, normal power supply | R808, 816, 823, 836, 840 changed check all of 4k7 | amsmariano | |
AIWA (SONY) | CX-NJ3 | When you increase the volume it only turns off | Faulty protection capacitors are 0.22x2w position on board r149, r150, r151and r152 | Replace the four with similar parallels or originals | jerson 37 |
AIWA | CX-NSZ51LH | Turns off when the sound is powered | Turn off transistor q130 | caio | |
AIWA | CX NS 888 LH | Red LED lights up but just clicks on the relay and nothing lights up | Pro 005 open and diode 001 changed | moroni eletronica |