Aiwa TV Repair: Common Faults and Solutions.
Search: Aiwa
Results: 309
Results: 309
Aiwa Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| AIWA | TV-AR295 RHB | With excess green and retrace of white lines. | The transistor q 710 shorted smd, thus increasing the voltage to 9 volts on the g output pin of the ic 101.. | Your replace. | house eletronica ltda |
| AIWA | NSX-V420 | Panel functions do not work correctly, only on the remote control | Solution: replace all touch switches | patrick | |
| AIWA | NSX570 | When I raised the volume the device turned off completely. | Q214 q215 smd can't be measured just by changing | vagner nardes | |
| AIWA | TV-C1400EZ PT23CO | It didn't turn on or show a stand by signal | 390k resistance r804 open | 390k resistor replacement | LASC |
| SOM AIWA | CX-NF969 | Shutting down, going into protection | Q224 k2937 | Replace it, I couldn't find another one, I called it without it and it worked | This email address is being protected from spambots. You need JavaScript enabled to view it., jaicós-PI,Ohm eletronica |
| AIWA | NSX-F12 | 5 cd carousel, motor does not have the strength to turn the carousel | 33Ω r changed CD board feeds q401 to 406 | Bruske | |
| AIWA | NSX-999 0118 | Panel lights up weak | Electrolytic c108 c107 | Solved | EDSON |
| AIWA | NSX-S22 | Nothing appears on the display | Open 27k resistor r116 is at the power supply | ||
| AIWA | AR295 | Power supply a little higher than normal and ticking on the power supply relay. does not generate high voltage. | 127k r820 open | Replace r820 | Edson S.A. |
| AIWA | CX-81MH | Display does not light up | Check c107 and c108 of 22uf | MATA | |
| AIWA | CX-81MH | Display does not light | C107 and c108 of 22uf dry | MATA | |
| AIWA | NSX-S22 | Don't read the CD for two rounds, play the laiser but don't read | Change the plate under the table and check the flats | Help yourself leave your tip | ELETRONICA ARNI-LEOBERTO LEAL /SC |
| AIWA | NSX-S22 | C dl | Optical unit | Help yourself leave your tip | ELETRONICA ARNI-LEOBERTO LEAL /SC |
| AIWA | NSX-S22 | Tsound is no sound on the CD, just a low noise, and on the radio, aux and normal deck | Optical unit | Help yourself leave your tip | ELETRONICA ARNI-LEOBERTO LEAL /SC |
| AIWA | NSX-S22 | Tsound is no sound on the CD, just a low noise, and on the radio, aux and normal deck | Optical unit | Help yourself leave your tip | ELETRONICA ARNI-LEOBERTO LEAL /SC |
| AIWA | NSX-S22 | Tsound is no sound on the CD, just a low noise, and on the radio, aux and normal deck | Change the plate under the table and check the flats | Help yourself leave your tip | ELETRONICA ARNI-LEOBERTO LEAL /SC |
| AIWA | F15 | Turns off by itself even without the box | Small pieces of wire break inside the box connector | Remove the connector and remove them, tsound are some that get stuck with the shorts | wendel |
| AIWA | CX-NS505 - NSX-S505 | The display lights up normally, after a few minutes it starts to flash slowly and increases until it goes out and some characters randomly light up. | Q102 (rn1410) | I removed the transistor, as I didn't have another one to replace it, I left it without it, and the device is working perfectly, without any problems. All device functions are working. | Aderbal |
| AIWA | NSX- S74 | Hoarse sound | Pr201 open | Adrian Chapadão | |
| AIWA | NSX- S74 | Turns on and off at the same time | Cap 3300yf/75v da power supply e q219 | Replace | Adrian Chapadão |