MITSUBISHI TV Repair: Common Faults and Solutions.
Search: MITSUBISHI
Results: 1346
Results: 1346
MITSUBISHI Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| MITSUBISHI | TC1482 | Vertical closed | C456 100x35 | ||
| MITSUBISHI | TC2010 | Cold solder on york cable horizontal output shorted and kinescope cut off toasted 10k abl resistor | After replacing the defective components, the image had little contrast, as I checked the abl line and tsound was nothing bad, I concluded that the tool was damaged. | I disconnected pin 10 of the ci, everything was done, the image was normal | Evandro/sousa astel eletonica ceara |
| MITSUBISHI | TC2054 | TV arrived with a burnt vertical ci mpc1488h, I replaced it with a ta 8403k and I also changed the c458 capacitor of 470 mf x 35 volts and the TV was broken | Burnt vertical ci | Electronics technician and installer of c or ku band satellite dishes for any satellite telephone for contacts -33 -30842033 | heliomar tecnico em governador valadares 33-30842033 |
| MITSUBISHI | TC 2098 | TV turns on normally and turns off in a few minutes and doesn't turn on again | R563 in the open acl line change the same | Francesco eletrônica Gine | |
| MITSUBISHI | TC-1492 | Does not light up on stand-by | D 905 short | HP ELETRONICA | |
| MITSUBISHI | TC2099 | TV inoperative, stand-by LED blinking | C907 exhausted (22uf/100v) | Replace c907 (22μF/100v) | Denys de Sene |
| MITSUBISHI | TC 2010 | Image without red | CI's video | Replace the same | macedo domingos |
| MITSUBISHI | TC 2010 | Image without red | Replace video ci | ||
| MITSUBISHI | TC 2098 | Power supply grilling-noise near the traffic | Cond. c907 22x100 replace without testing | kin | |
| MITSUBISHI | TC2098 | Q horiz exit. burned. high pulsating power supply from 100 to 200v | Weak capacitors near the regulator. | Replace c905,906.check c551 | kin |
| MITSUBISHI | TC-2099 | Image with interference without synchronization | Tda4662, c208,c705 | Replace | ELETROCLAUDIOPE AGUAS BELAS |
| MITSUBISHI | TC-1499 TC-2099 TC-20A | LED lights up and then turns off at high power | R952 changed and c907 with esr changed | I replaced the r952, after that the LED was just blinking, I replaced the c907 and closed the lid | Bruno Capozzoli |
| MITSUBISHI | TC2098 | Snoring in the sound as image varies | Cf301 proximo do varicap | Replace cf301 4.5m | apoloxxx |
| MITSUBISHI | FP2101 | Vertical closed, bright list in the middle of the screen | Ic 101 la76932n 7l | próton eletrônica Avelino lopes,pi | |
| MITSUBISHI | TC2009 | On and off. | 9 volt regulator. | Replace regulator ic251. | R-TEC Eletrônica |
| MITSUBISHI | TC-1499 TC-2099 TC-20A | Just measure on a high scale, replace and that's it. | C920 with leak | Just measure on a high scale, replace and that's it. | Bruno Capozzoli |
| MITSUBISHI | TC-1499 TC-2099 TC-20A | Just turn on the LED | D953 zener 6,8v | Tsound is no point in measuring what measures as good, you have to replace it | Bruno Capozzoli |
| MITSUBISHI | TC-20 | Dull TV, horizontal bands behind the image, remote control accesses the menu, but does not navigate through the options | Horizontal bands, cause: c705 and c703 of 1mf x 50 volts, no brightness, cause: adjustment of the scrim screen and brightness in the TV menu, remote control accesses the menu, but does not navigate the options: tsound are several parallel controls that do not have the function keys | This TV was a gift from a Greek that was donated to me, after years of leaning on it I decided to touch it, when I turned it on, only a light blue screen appeared, I know that this TV has this screen protection when tsound was no signal, I connected it to the antenna, the image appeared, but without brightness , I acted on the screen and it showed an image, but with horizontal bands behind the image, I replaced the c705 and c703 of 1mf x 50 volts which were shorted and resolved, I bought a remote control that accessed everything except navigating the menu to adjust them, so I researched and got tips that said it included the eeprom, I remembered that this TV came with a remote control when I got it, I looked for it... I even thought I repaired it because it was defective, I went into the menu, I adjusted the brightness, color, etc. I re-adjusted the screen and blz, the parallel control did not have function keys to navigate the menu | ivan@ |
| MITSUBISHI | TC-2098 | Does not turn on, stand-by LED is off | Short ic901(str-s6707), res.r900/902/905 open, fuse f901 open | Replace them all, check cap.elet.c905/906/907. | jheliocavalcanti |
| MITSUBISHI | 2098 | Warming up q901 | Change without testing c905 and c906 | kin |