Search: MITSUBISHI
Results: 1346

MITSUBISHI Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
MITSUBISHITC2099
TV stuck in function lock1) with the TV turned off, press the channel + button and then the channel - button. the TV will turn on;heliomar
MITSUBISHITC2099
TV stuck in function lockUnlocking mitsubishi mod tv. tc-2099heliomar
MITSUBISHITC 2099
Poor focus, no visible image appears (blurred tube)Bad tube socketRemember that one hand washes the other.Marcone This email address is being protected from spambots. You need JavaScript enabled to view it.
MITSUBISHITC1498
Black stripes passing diagonally across the screenC-705Capacitor replaced near bnmicro c-705edivaldo
MITSUBISHITC-2098
Does not oscillate the primary power supplyR-904 = 47k x 1/2wFERNANDO S
MITSUBISHITC2098
Closed vertical.With the TV unplugged, we placed an external power supply on the +b 25volt line that polarizes the vertical, in series with a 40W lamp. The lamp turned on at full brightness. IC 451 was shorted.Replaced ic451 ta8403k, and the r465 1r opened due to the short in ic 451, the TV returned to normal.Lucas40
MITSUBISHIñ SEI
This TV just has a blinking LED and it doesn't turn onA 16v 470uf capacitorIt was replaced and it's all good. Friends, I'm sorry I don't know the model of this TV.This email address is being protected from spambots. You need JavaScript enabled to view it.
MITSUBISHITC-2099
All white screen with background lines24c2 memory replacement24c2 memory replacement resolvedH.IM ELETRONICA
MITSUBISHI2098
(image out of focus)Bad picture tube socketMarcone
MITSUBISHITC2098
No video with horizontal black stripes.Trimpot vr654=220r cracked, green cathode regulator.Just replaced it and adjusted it, it was ok.Armando da Eletronica Só Tv
MITSUBISHITC-2098
Low power supply does not oscillate3r3 power supply resistor in place of the 0.33r resistorPut the correct resistor 0.33rEletroclaudio Aguas Belas PE
MITSUBISHITC-2009
Turns off after a few minutesD714 5v6 changedReplacepaulo maceio/al
MITSUBISHITC 1418PS
It doesn't turn on, it just stays on standbyR 571 and c567 causing heating of r571
MITSUBISHITC-2098
Completely stopped, charging the power supply capacitor.R900 er905 and see if str s6707 is shortedJust to be sure, replace capacitors c905 and c906This email address is being protected from spambots. You need JavaScript enabled to view it.
MITSUBISHITC1492
Does not accept the power commandC915 and 917 470mx35v replace@gepê
MITSUBISHITC21S
QUE USAN O MICRO M327210 E O TDA8361
Agc doesn't workChange values ​​of c120 and c132Do not measure but replace c120 2.2mf and c132 82pfars
MITSUBISHI2099
Mitsubishi tc 2099 with sound, white screen with diagonal lines (horizontal phase)Q 705renato tranca forte
MITSUBISHITC-1410
TV does not oscillate, press the button to turn it on, the LED goes off and comes on againCold solder on pin 10 of the fly back and open 8r2 5w r571Resolder and replace the resistoreletroclaudio aguas belas
MITSUBISHITC-2018
You plug the TV into the socket and it oscillates for 3s and goes into protection mode.Protection activatedLook at the most critical components such as flyback, horizontal and vertical output, if these have a bullet, measure the voltages of the 901 regulator (str f5654), if the voltages are ok, turn off the diode (953), 18.6v, the TV will turn on and oscillate normally and it will show wsound the defect is, in my case it was the vertical output and the IC (701), this one came from another workshop I believe it was just the vertical one, because the IC 701 had new solder, unfortunately tsound is a workshop that uses From this bad faith, a hugffeet
MITSUBISHI1418 PS
Capacitor 955 bursting and r 952 openingC 567 sold out 4.7 x 160Replace the sameurbieta