MITSUBISHI TV Repair: Common Faults and Solutions.
Search: MITSUBISHI
Results: 1346
Results: 1346
MITSUBISHI Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| MITSUBISHI | TC-2910 | Vertical closed and burning horizontal exit | C201 470mf/16v shorted next to ic251 | Replacement | paulo-maceio/al |
| MITSUBISHI | TC-2018 | TV cutting out sound and not obeying commands either on the panel or on the remote control | 5v supply on the clock and date line and high vcc | Check the entire power supply including the load diodes (connected to ground) the power supply must be 5v round | CSOM-(066)34231060 |
| MITSUBISHI | TV-2099 | Blinking led | C 901 | ||
| MITSUBISHI | TC2910 | TV with two wavy bands on the sides | After measuring almost everything in the horizontal sector I found an open resistor r561 of 4 r7 | It was just a matter of changing it and the TV was ready! | plramos |
| MITSUBISHI | TC-2098 | Vertical closed and scratches at the top of the screen | Low voltage at the power supply and burning r456 | D458 shorted vertical output shorted replace these components, when opening the vertical if scratches appear on the screen at the top of the screen replace c453 it is not necessary however if you want to replace c459, c457 is optional and go for the hug | ffeet |
| MITSUBISHI | TC 1499/2099/TC20A | Normal image but with diagonal bars going up behind the image | Was it worth changing the 1uf/50 c705? | JUVENAL PICOS-PI | |
| MITSUBISHI | TC-2090 | Does not turn on, and you can only hear the noise of the horizontal working. | R-562 open | Carbonari | |
| MITSUBISHI | TC 2099 | Has audio but no sync | Q 705 short | JF ELETRONIC | |
| MITSUBISHI | TC-1409 | Image with little brightness as if the tube was weak | R 559 of 220k open on the abl line | Replaced solved the problem | NOELSON |
| MITSUBISHI | TC-1410 | The TV stays on stand by in power on, the Apga LED but the TV doesn't turn on | It gives the impression that the TV is going to turn on, but the power supply keeps oscillating | On standby measure the voltage on the collector q551 (voltage on standby by 114v dc) any voltage drop on this collector could be a three-component leak (q551, c573 or c572) | Marcio Rossi |
| MITSUBISHI | TC-2099 | The stand-bye LED flashes, accompanied by a pulsating noise at the same intervals as the LED. | Power supply capacitor - replaced power supply capacitor c907 (TV works perfectly again) | Replaced power supply capacitor c907 (TV works perfectly again) | |
| MITSUBISHI | TC2098 PCB-MAIN | Vertical closed yellow line | R-458 22k | ||
| MITSUBISHI | TC2098 | TV with a line in the middle of the screen from top to bottom | C574 just change it and that's it | plramos | |
| MITSUBISHI | TC2099 | Timing | Replace cap. c208 1/50v | digitos | |
| MITSUBISHI. | TC2097, 2098E, 2099 | If the power supply only gives 50 volts and does not give 120v, the LED will just blink. | Capacitors c907 and c906 with low capacity. | In place of c907 with one of 22μF for 100 volts and in place of c906 for one of 47μF for 25 volts. | ARMANDO DA ELETRONICA SÓ TV. |
| MITSUBISHI | TC2090 | No color | Fiu | First look at the service key, it also removes the color | EVOLUSOM |
| MITSUBISHI | TC-2098 | Does not come out of standby | Replace c905 de 220mf x 16v | Persio(TVCOMPANY) | |
| MITSUBISHI | 14 | ñ it works | R 906 (brown,black,brown) | Replace it | FURAO |
| MITSUBISHI | TC-1631 | Image is black and white, you have to pay for color | Change the service key in the vertical region or leave it without the key ok | Help yourself leave your tip | ELETRONICA ARNI-LEOBERTO LEAL /SC |
| MITSUBISHI | TC-1631 | Vertical keeps closing sometimes it opens | Change the service key in the vertical region or leave it without the key ok | Help yourself leave your tip | ELETRONICA ARNI-LEOBERTO LEAL /SC |