PHILCO TV Repair: Common Faults and Solutions.
Search: PHILCO
Results: 4741
Results: 4741
PHILCO Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILCO | TP-2054 | Normal power supplys the TV turns on and takes a while to light up the screen, sometimes it lights up with a horizontal bar, other times the screen keeps flashing with retrace lines (a symptom of the lack of 180v voltage) however this fault is caused by the 715/730 polyester capacitor metallized 6n8x1600v with low capacitance (below 3n) | Replacement of capacitor 715/730 metallized polyester 6n8x1600v | WAGGUINHO | |
PHILCO | PCS2952 | Dull | The defective component was the open resistor r718 (also change the zenerzd702) a horizontal pulse is responsible for the operation of ci pin 38, fbp in | Note: I noticed that this pulse is common for all brands and models that use the ci 8361/8360/8362. | DJALMA MILAN |
PHILCO | PC1443 | Horizontally shrunken and vertically closed | Main cause of this problem (l701), then q901 q 904 and 905 lastly ic 101. I fixed it was l701. | Elias2305 | |
PHILCO | 2046 | The TV does not tune the channel | It had 33v on the seletronic bt but it didn't have os9v on the seletronic bm so I went to the IC 701 regulator and it was ok I then discovered a broken track I built a bridge on it and it was broken | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
PHILCO | PCM1446/2046 | When the TV was turned on, it just stayed on stand by and didn't wake up or flicker. | I checked its power supply and at the output tsound is a 220mf/160v c911 capacitor, it was dry, it didn't even measure 1 mf, I replaced it and it worked normally | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
PHILCO | TP29C21 | Fountain oscillating, making noise tick tick tick... | Replace fly-back | Scorpion | |
PHILCO | TP-2054 | Turns it on and off, no brightness appears | Check r 910-912 0.47r diode d809 | Diode short TV won't turn on | Alvaro (prolar) |
PHILCO | TP1454 - 2054 | Activating protection circuit and does not turn on | See if 905 shorted behind the sensor = remote | ||
PHILCO | PCM-2144 | Oscillating color | Ic 102 memoria 80011a | Alvaro (prolar) | |
PHILCO | PC 1425 CPH 02 | Does not adjust phase | Resistor r724 de 22k no pino 11 do ic 701 | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
PHILCO | TP1452N | It didn't turn on, the LED was on, when I pressed the channel button it went off and then came back on again. | I replaced the ci 101 - m37272m8-194sp and it worked great | Luiz Alberto Camargo | |
PHILCO | PCS-2976S | Ripple on the sides of the image | Capacitor smd c931 | Replace | Alvaro(prolar) |
PHILCO | PC2044 | Without generation, with the LED on, normal +b voltage. | C915 almost dry 1000mf | Ramiro Lima | |
PHILCO | PC2043 | Contrast doesn't work | O d301 with leak, r716 open | Ramiro Lima | |
PHILCO | PC1443 | It works normally, but if it turns off and turns on at the same time, it no longer turns on and the +b remains normal. | Swap c706 22k | Ramiro Lima | |
PHILCO | PC1443 | With a normal image, tsound are just no characters on the screen. | Verificar r-505,r-504,r-510,r-716, r-717,r-714,r-718,r-706,r-612,r-173,r-172,r-171,r-613, zd-601. | Ramiro Lima | |
PHILCO | PC1446 | Without generating, with voltages all normal and LED just blinking | R705 open from 560r | Ramiro Lima | |
PHILCO | PC1446 | Generates and cuts after 10 seconds, only 300v remains, if you release the +b, on the deflector it generates normally. | Zd-703,c-708,c-908,zd-903.replace. | Ramiro Lima | |
PHILCO | PCM1451 | Without generates and without +b. | Tda-4605-3 | Ramiro Lima | |
PHILCO | PC1446 | Without generating but with the normal +b, the normal 20v, just doesn't reach the collector horizontal oscillator. | Tda-8360k-4x | Ramiro Lima |