PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14171
Results: 14171
PHILIPS Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS | 20PT 326A/78R | Ñ league. | Capacitor 2409(47uf/160v) e capacitor 2551(47uf/160v) | Replace them. | BARRETO CRUZ |
PHILIPS | 37PFL5332 | Turns on the image appears for 15 seconds and turns off | U-202 change without measuring | VIDEOTRON | |
PHILIPS | 20PT324A L9.2 | Very weak channel reception | Filter 1003 (m1967m) | joaomvjr | |
PHILIPS | 21PT9467C SK-1LCA | Turns on with image and no sound, doesn't turn on, locks keyboard, turns on only with drizzle or white screen. | Zd604 | saffier | |
PHILIPS | 29PT5645 | No image | Shorted picture tube | Replace tube | ELETRONICA MAURI JUNIOR |
PHILIPS | 20PFL5122 | There is no image, the lamps do not light up | A faulty light bulb triggers the protection and no one lights up | You need to replace it with a good bulb to avoid triggering the protection, just leave it off | eletronicaaeb |
PHILIPS | 20GX1669 | Does not turn on LED blinks 2 times | Ci vertical | Tda8351 | ELETRONICA MAURI JUNIOR |
PHILIPS | 21PT1663 L7.2E | Doesn't start. LED blinks weakly and without voltage at the power supply output | C2550 | Substituir c2550 | jose almeida tavares |
PHILIPS | 25PT5321/11 GR2.4 | When turned on, the image appears for 1 or 2 seconds, then the screen is dark with return lines and a light line at the top. If you change the screen a little, the video tends to appear very dark. | One of the kinescope's cathodes is nearly short-circuited. in my case it was blue (I tested the cathodes with a rejuvenator). | Use a kinescope rejuvenator to eliminate possible short circuits in the cathodes. | AleVict |
PHILIPS | 29PT4635/78 | White lines across the screen as if it were normal high sound screem and it doesn't turn off.l | R3477 from 150r open. | hndrsn | |
PHILIPS | GR 1045... GR1L1I-VA- RO3 | After changing the fly back, only the LED and the 35V power supply blink. | +12v protection activated | Raise d6904, if it works, put a 13v one | jasvan souza |
PHILIPS | 29PT4635 | It turned on and then turned off, I changed it c2455 47u turned it on and held it but the screen is closed and serrated. | Check the deflector as it makes a strange noise. | Changing it is beautiful (dhf-2912pl) 1.8 to 2Ω horizontally and 13.6Ω vertically. | Eronaldo(arteron) |
PHILIPS | 29PT554/78R | The TV sometimes turns on and sometimes doesn't, when it doesn't turn on the LED blinks continuously and the b keeps pulsing. | The power supply does not activate, the slow starter does not work. | C2540=100μF 25v was replaced, it was average in the test at 80μF, and c2530 of 1μFx100v was also replaced, I replaced the c2530 with a 2.2 x 100v one, I replaced the value of the original and it worked beautifully. | Armando da Eletronica EvoluSom. |
PHILIPS | 14PT3336 | Vertical closed | Varicap | Replace varicap | ELETRONICA MAURI JUNIOR |
PHILIPS | 29PT558 L01.1L | Hits the relay and doesn't turn on. | R3543 (82k) | Replace | joaomvjr |
PHILIPS | 29PT554A | Retrace and disconnect lines (without 180v) | R3340 pci tube 0bs: measure d6335 sometimes with leakage and the r3340 burns again! | Guto | |
PHILIPS | 14GL1015 | Low brightness, opaque image | R3555 (27k) open | Replace and run for the hug | Eletrônica Staub |
PHILIPS | 21PT5433 | Doesn't start | Check resistor 3527 primary power supply | amsmariano | |
PHILIPS | 14PT3131/78R | Retrace lines at the top of the image | 68nf/250v dry capacitor position 2460 | As I didn't have a 250 volt one in stock, I replaced it with a 50 volt one since the vertical one works with low voltage. | Helio Eletrosonic |
PHILIPS | 40PFL5605D/78 | Total shutdown. | D707 and d711. I used the uf4004 because the 1n4004 is not a quick cut and here in Belém the material is complicated. | I appreciate the tips from friends. ferraz, bruske and electronicaaeb. | @gepe |