PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14171
Results: 14171
PHILIPS Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS | FWM416 | No sound | Amplifier on level under pin 13 of the stk433-870 | Replace q721/716 2n5551=mpsa42 e q722 bc556 | VITALTEC |
PHILIPS | 16GL1333 | Low 5 v supply, screen with retraces, no image and sound | Ceramic cap 2953 short | pardalzito | |
PHILIPS | 20PT424 | The LED keeps shaking and horizontally | Adjust +b in power supply | Agnaldo | |
PHILIPS | 21PT9467 | TV does not turn on, only standby access | I checked the power supply first, everything ok, secondary diodes, everything ok. bad flayback.. I changed the flayback, more vertical closed, replaced ci tda4865, changed the diodes, capacitors and resistors of the negative supply line of this ci and the 185v line | Replace of flyback + vertical output + capacitors diodes and resistors of the negative line of the tda8565 and the 185v line | Fenixtec |
PHILIPS | 29PT4643/78 | Dead power supply | D 6536 | Replace it | TIAGO.ELETRO |
PHILIPS | 42PFL3604 | Don't tune in | Bad selector/varicap. Note: there is no 33v power supply requested in the manual. | Replace selector/varicap | |
PHILIPS | 42PFL3604 | Does not turn on, stays on standby | Capacitor c806 sem carga. 4.7uf/400v | Replace the capacitor | LUCIO |
PHILIPS | 20PT336A;78R | The filament turns on, gives a flash and turns off | 100uf25v and 1uf50v capacitors both power supply close to the 3540 trimpot | Replace both, both were dry, very low capacitance | janilson |
PHILIPS | 14PT218A | Menu appears on the screen and does not obey commands | C 2006 with escape. the same is on pin 80 of the micro | Replace it or withdraw it | antonio vinicius alexandre nobrega |
PHILIPS | 28PW6532/78R | When you turn it on, it turns off and on, off and on... | Bcs 337 and 327 replaced by bd139 and 136 | manin | |
PHILIPS | 20GX1656 | Image with small waves, almost serrated | Ver c 2531 | Master eletrônica | |
PHILIPS | 29PT4635 | Doesn't start | D-6467 / d-6464 (smd aberto) | Replace with 1n4148 | This email address is being protected from spambots. You need JavaScript enabled to view it. |
PHILIPS | 20PT3336/76 | Dark screen with characters; and normal sound | 100k open resistor r3442 | DIEGO LIMA NOVA TIMBOTEUA PA | |
PHILIPS | 20PT3331/78 CH | Turns on with three colored lines and a closed image at the top of the screen and turns off. | I replaced the c2460 and adjusted the screen, the TV started working normally again. | Marcelo Sperb | |
PHILIPS | 29SX8879 | Completely stopped | R 3136 =820k open | ramiresrc | |
PHILIPS | 29PT6566/78 SL04L11 | Normal image, sound hissing on all channels, I didn't hear any voice, if I increase the volume, the hiss only increases. | Enter service mode and change audio qss from on to off | hndrsn | |
PHILIPS | 29PT 552A | If no power supply, or just the LED blinks | Can be c2463 220/2kv or c2550 with small leak | Remove, for testing, if it works, replace. | jasvan souza |
PHILIPS | 29PT552A | Measure, if bad, replace | C2551 and c2450 with good appearance but exhausted (47/160v both) | Measure, if bad, replace | jasvan souza |
PHILIPS | 29PT552A | Measure, if bad, replace | C2551 and c2450 with good appearance but exhausted (47/160v both) | Measure, if bad, replace | jasvan souza |
PHILIPS | 40PFL6605 | Does not turn on, nor does the stand by LED light up | D911/d907 diodes (sb260), as I couldn't find these diodes I put the sb560, it worked perfectly. | These diodes are on the secondary of the power supply | MauriÃlio |