PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14168
Results: 14168
PHILIPS Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS | 43PFG5100 | No image, back light on | C202 on the display board. Pay attention because the first time I measured it did not present a short, however it had a low resistance. | Replaced it with another plate removed from a broken screen and it worked perfectly. It is very important to add another one and never leave it without a capacitor. | Mário Fernandes Testoni Junior |
| PHILIPS | 42PFL3507 | TV does not light up on standby. correct power supply voltages. | U702 - 3.3v (releasing only 2.5v). | Replace regulator u702 - 3.3v on the main board (an ams1117 - 3.3v was placed in its place, it worked perfectly). | Company Tronics |
| PHILIPS | 32PFL3605 | No image, with stripes, and making a noise on the main board | 750k resistor on the bottom of the board next to the flat cable that goes to the screen | Rodrigo cofferi | |
| PHILIPS | 32PFL5604H Q543.3E | Does not start LED blinks 3x | C513 10nf1000v na power supply | LUIS ALBINO | |
| PANELA A VAPOR PHILIPS | R19140/90/A | Does not turn on without power on the PCI board | Causes l1 open with a lot of glue on the contacts | Replace the l1 on the board and remove the glue, in my case I cleaned it with thinner | Francisco Medeiros/ Barbacena MG |
| PHILIPS | FX50X/78 | Inoperative does not turn on anything | Tps 54260 shorted and zd 753 (zener 5.6v) shorted, diode d6 (s8) leaking | Replace the tps 54260, the 5.6 zener and the s8 can be replaced for the 1n4148 (it's a gem) | RDV ELETRONICA E SERVICOS |
| PHILIPS | 46PFL7606 | LED blinks 2 times but doesn't turn on | Fuse 1u40 t3a32v open. check possible short in ceramic capacitors in this line | Jocimar | |
| PHILIPS | 14GL1015 | Heating fet from the power supply until it burns | R3321 of 100r changed (main cause), 7321 bc548 with leak between collector and emitter, diode 6346 (zener 91v) with leak | Replace without testing components mentioned above | HAHNRAHN |
| PHILIPS | 32PFL3404/78 | When exchanging the main board for another model, the display was incompatible, leaving the screen with no information whatsoever. | Replace memory u21 from the old board for it or rewrite this memory with the correct model data.. (u21= 24c32wp) | EC | |
| PHILIPS | 26PFL3322 26PFL5322 32PFL3322 | Does not turn on, 5v voltage comes and drops. | Replace ic602 and ic902. | <small>electronicssupplyparts - Gramado/RS</small> | |
| PHILIPS | 32PFL3605D | Inoperative damaged power supply | Power supply repair | R513-220r smd, r514-10r smd, r515-10k smd, r518-24k smd, r519-100r smd, r520-100k smd, r517-0,33r 2w metal filme, d510-μF4007, zd503-5,6v, d210-sb3200, u501-ncp1207 smd, q501-fqpf6n80c, d503 e d504-4148, q101-kst222, q111-kst2907, c502-100pfx1kv | NEI |
| PHILIPS | 14PT3131/78 | Retrace and hang lines | R3476 burned | Measure and replace 8k2 r3476 | eletronica o gilvan |
| PHILIPS | AZ1845 | Low sound on one of the channels | Electrolytic capacitor 470/16 c901 | Electrolytic capacitor 470/16 c901 | RPS TECNOLOGIA |
| PHILIPS | 32PHG4900/78 | Doesn't work | No voltage in the power supply connector to the main | Diode d9110 shorted, replace with another equal or higher in voltage and current | Lucas |
| PHILIPS | 42PFL3604 | Inoperative. | L807 aberta, primary from pci power supply. | electronicssupplyparts - Gramado/RS | |
| PHILIPS | 42PFL3507 | Audio going mute when it heats up | Change 3.3v regulator + 220/16v smd electrolytic capacitor on its side | reginaldo moronte,eletronica junior caldas novas | |
| PHILIPS | 40PFG4309/78 | Lock with the message "enter pin" | Philips TV 40pfg4309/78, suddenly, while watching a program, the screen would freeze and a rectangle would appear with the message "insert pin". I looked for information that the default Philips pin was 8888 (it worked but it soon came back). I tried to solve it using the remote control but I didn't find the way. I found a firmware update on the Philips website and installed it via pendrive but it didn't help. So I ended up finding how to solve it using the control: home key/configure/configure channel/child lock/block via content. Tsound are three options to select from: drugs, violence and sex. On this TV, sex was selected (even though no one had programmed it). All you had to do was uncheck this option and the problem was resolved. | littlecarlos | |
| PHILIPS | 21PT5433/78 | Turns on with the image moving to the side with a black band and turns off | Replace diodo smd 6451 | Dj pituca | |
| PHILIPS | 21PT5433/78 | Turns on with the image moving to the side with a black band and turns off | Replace diodo smd 6451 | Dj pituca | |
| PHILIPS | FMW 208 | Doesn't start | C smdem short 104 burned the bridge and fuse | Replace components. install the bridge outside the board with heatsink, heatsink on the q501, place 2 103 caps, one in parallel with r540 and the other with r543, making the woofer with bass and mid-bass. it turned out great. | Warley cesar |