PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14168
Results: 14168
PHILIPS Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS | 21PT9467C/78 | League without sound and image, with characters | D302 1n4148 with leak, you have to remove it to measure | To replace. tip sound from the channel | GDP2 Macajuba-ba |
| PHILIPS | 14GL1016/78 | Turns on with sound, and without image. | Bad flyback, just change it, it will return to normal. | Marcones de Araripina-PE | |
| PHILIPS | FX20X/78 SOM | Doesn't start | Check the power supply. In my case it was some rusty components ex jumper and diodes. | Replace and repair. | JC Eletrônica Cícero |
| PHILIPS | 196V3LSB2/78 | Does not turn on backlight | 10v capacitor by 680uf on the power supply board on the 5v line | Replaced with a 16v capacitor for 1000μF | Claudio Eckert |
| PHILIPS | 32PFL3606 EL1108.05 | No image, power supply voltages ok, back light coming on, sound ok | Mainboard resistor 7503-750k is close to ci k1 | Dinho | |
| PHILIPS | 26PF5321 | TV only turned on after several attempts and warming up. | Capacitor c130 - 100uf x 25v on the device's power supply board. | I replaced the c130 capacitor with the same capacitance. As I didn't have a 25v capacitor on my bench, I placed one with a higher voltage limit: 50v. This modification is not problematic, you just have to respect the minimum limit and place it equal or higher. | Villeneve Oliveira |
| PHILIPS | 32PFL5403 LC8.1L LA | Doesn't start | Absence of 3.3v | Changing the r929, 1r resistor that works as a fuse, if not, I replaced it with 1r1 | Zener Serviço Técnico |
| PHILIPS | AZ1133 | Sound on normal CD, am and fm with very low sound, you can only hear it if you put your ear to the speaker | 1000p smd capacitor, position c82 (has lap on it). | Replace capacitor smd c82. | J&M |
| PHILIPS | 32PFL3404 TCM3.1L | It turns off in a few minutes, sometimes tsound is a beep from the speaker, it does not obey commands from the remote control or the TV. | Lack of grounding in the housing of the x5 crystal (16mhz) close to u8. definitive solution | Take a piece of bare jamper, go around the crystal and solder it to the housing and to a ground point. Obstodo topics previously sent are correlated to this defect. | cici.muniz |
| PHILIPS | 40PFG5000 | Lowering the current of the LEDs so they don't burn | Retire os resistores smd r8614 r8615 r8616 | reginaldo moronte,eletronica junior caldas novas | |
| PHILIPS | 32PFL3707 | All total dead stop | Power supply | Replace d9104,q9107,d9107/zd9106 and r;9159 because tsound was a power outage burning these components, just replace them in my case, ok, luck to everyone, aai | eletronica publison natal rgn |
| PHILIPS | 50PFG4109 | Reducing the current of the LEDs to avoid burning | Remove the smd resistors from the board r8148,r8149,r8144 | reginaldo moronte,eletronica junior caldas novas | |
| PHILIPS | 42PFL5007G/78 | Em stend bey | Poor contact on the t501 transformer on the primary power supply. | Remove the welds and redo them all regarding the t501 | MULTIMARCAS/ACARI |
| PHILIPS | 40PFL5606D/78 | Completely stopped, 3.3v present... | Short on the 12 volt line... I found shorted 10mfd smd capacitors, they are connected to pin 2 of the ci 7125. check surrounding components. good luck... | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
| PHILIPS | 32PHG5813 | No image with sound | LED bar make the change and change the five current resistors until you get 1.2r | Replace the LED and replace the value of the resistors and that's it | orlando lott |
| PHILIPS | FWM 417X/78 HC01109084974 | Locked, does not come out of standby | Condultor na pci do cd l554 aberto | Replace | JOÃOELETRONICO |
| PHILIPS | 42PFL5007G | Changing +12v supply voltages, turning off when starting | Faulty photocoupler | Replace pc501, el817 | HAHNRAHN |
| PHILIPS | 20PT3331/78 | Turns on with the screen off low power supply | Fotoacloplado | Photocoupled replace | Cícero ajude pra se ajudado |
| PHILIPS | 32PFL4017G | Negative image | Lvds cable at the tcom input with zinabre, cleaning was carried out, the tv returned to normal | jorge | |
| PHILIPS | 42PFG6809/78 | Backlight off | Checked pfc inoperative, it is part of the circuit that powers the backlight power supply | Remove and clean glue from r 9801, 9802 and 9803. | Ricardo RR |