PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14168
Results: 14168
PHILIPS Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS | 32PHG5102/78 AF511805056800 | Doesn't even turn on the LED | Remains of light | Defect | Rosario |
| PHILIPS | 32PHG5102/78 AF511805056800 | Doesn't even turn on the LED | Remains of light | Rosario | |
| PHILIPS | 32PFL3008/78 | Screen turns blue and turns off | I don't know | I don't know | Ismael |
| PHILIPS | 40PFL7007T/12 FSP163-4FS01 | Error code 3. dead | Verificar/substituir f1(4a); q101, q102 (20n60c3); d102, d103 (bav70w); zd101 (9v1); r122, r130 (5r1); r124, r131 (30r); r125, r128 (10r); u101 (ssc9522s); | Rui | |
| PHILIPS | 32PFL5403/78 | Power supply turning on standby with 3.3v! but without 12v!! | Ic901. dda001bg | Replacement | Rodrigo cofferi |
| PHILIPS | 21PT5433/78R | LED lights up when pressing CR power goes off +b at around 120v and the TV does not oscillate | Transistor 7422 open, change and move on to the next one. | samuel leite | |
| PHILIPS | FWM377 | Does not turn on only displays clock and standby | Replace of q312 d882. Remembering that if the CD board and all the flats are not connected, the device will not work. | Mitzko eletrônica | |
| PHILIPS | FWM663X/78 | Nothing turns on, not even the LED | Diode 15 in the secondary power supply close to capacitors 13 and 14 it was shorted | MARCOR ELETRONICA | |
| PHILIPS | 42PFL4007 | Totally inoperative | Changing the hdmi switching ci | Replace ci hdmi | SAS ELETRÔNICA |
| PHILIPS | 42PFL7007/78 | LED on, it has 3.3v, not 12v, it has vcc 17v but it doesn't start. | Transistor q603, (stk0160) mosfet similar to a bc547, was shorted asking for the switch. of the ic600. | Floor under por 5n60 uo 6n,7n etc.. | GDP2 |
| PHILIPS | 32PFL3404/78 | Turns on, after a short while it makes a loud hissing noise from the speakers and turns off | Defect in capacitors | According to tips from colleagues, I replaced capacitors on the main board, c474, c110, c532, c534 and x4 oscillator crystal, first of all replace the c110 capacitor, then the other capacitors and lastly the oscillator crystal | Claudio Eckert |
| PHILIPS | 32PFG 5103 | Does not turn on, nor does standby light up | R9101 (0.27r) changed | Luis fischoeder | |
| PHILIPS | 14PT3131/78R | Dark image but with some characters | 3442 resistor near open flay-bak | MARCOR ELETRONICA | |
| PHILIPS | 50PUG6700 50PUG | Defect, nothing turned on, no 12 volt voltage, necessary to turn on the TV | Snd diode below the power supply board, short, sk510c | Replace sk510c diode is below the power supply board.smd, sk510c 150 v.5 amp. | Eletrônica Moisés N.H |
| PHILIPS | 221TE4L | Totally dead | Cap´c922 470/10 is not and c911 does not exist | Cap. 470/25 | rn eletronica ce |
| PHILIPS | 42PFL7412/78 | Screen flashes and turns off, returning to standby bay, if you press power, it turns on again, but if you move it, it turns off again. | U202 photo coupler, just change it. | This power supply has 4 photo couplers. This defect is more common in the u202. | |
| PHILIPS | FWM462X/78 | Does not leave stand bay | Coil that feeds the CD drive 8 v supply in series with it before it has a 22 r resistor also check, in this case it can be seen that the mechanics do not work | Replace the coil and check the carousel and tray belts! Please note, this device only works if the CD mechanics are perfect. | |
| PHILIPS | 40PUG6300/78 | Doesn't start. primary power supply only | Large smd diode on the 12 volt line. good luck to everyone! | Eletrônica Cecé. Brumadinho MG | |
| PHILIPS | 29PT4635 | Horizontal lines in the image at the top of the screen | C2487 | CARLOS ELETRONICA | |
| PHILIPS | 42PFL3604/78 | LED on and not turning on / 3.3 volts oscillating | C806 |