PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14168
Results: 14168
PHILIPS Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS | 221B11TB | Turns on but the screen stays white bad image. | Resolder the regulators u701, u703, u707, u708, check the 5v supply, if it is low, replace c930, c915. | Resolder regulators u701, u703, u707, u708 check the 5v supply, if it is low, replace c930, c915. | Marcelotj - RENTEC |
| PHILIPS | PFG5813 | It doesn't turn on, just the power supply works, and pci main doesn't work | Short at the output of the u701 +b5v those smd that usually short out close to the u701 = 10uf | "direct to the defect" channel with more tips | BRUSKE |
| PHILIPS | 32PFL3404/78 | Blowing fuse, turns on weakly and turns off | Cw2 cw4 = 220p *221* // ch1 ch2 = 1000p *102* // qh1 qh2 = 2sk3561 | Replace capacitors and mosfets 3561 can be 3568 3569 located in LG philco power supplys etc. | XLA ELETRONICA |
| PHILIPS | 42PFL3207H/12 | No image | After trying to update the firmware and entering the screen type code 062598-home-label number on the TV and without results, I decided to check the t-con board, I found a short diode and it was replaced, everything worked normally. ss54 reference diode. | jose almeida tavares | |
| PHILIPS | 32PFL4007 | No audio | Shorted audio ci | Replace the ci that is shorted | marco.32 |
| PHILIPS | 32PFL3406/78 L11M1.1L LA | Tsound are times when it turns on / tsound are times when it goes days without turning on | Ci 7122 rt8283ahgsp faulty 3v3 regulator, 3v3 voltage with less than 1v3 | Replace ci 7122 rt8283ahgsp regulator 3v3 | NILSON |
| PHILIPS | 32PHG5102/78 | Does not turn on inoperative | Led stand by apagado | Causes r 9101 of 0.27 r | Gilvan |
| PHILIPS | 43PFG5813 | Doesn't start | Ci 3s121 | Replace do ci u9101 | cleber lima rs |
| PHILIPS | FWP2000X/78 | It didn't turn on, the speaker LEDs kept blinking, it only turned on after 2 hours in the socket | Capacitor of 47 mf/35 volts as low capacitance around 34 mf | Another new 47mf/50volt was installed and it was perfect | eletronica rodrigues |
| PHILIPS | 32PFL3008D/78 | When plugging into the socket, the blakclilat turns on and then turns off when powering the LEDs with an external power supply, you notice the screens changing if the screen is tested | Eprom memory | The eprom was removed. and turned on the TV without it in place. Then I replaced the eprom itself and the TV returned to normal operation without turning it off again. | Nunes |
| PHILIPS | 42PFL3007D/78 | Turning off the screen but keeping the TV on | Voltage regulator exceeding voltage, overheating. | Replace voltage regulator g1084-33 3.3v 5a | Max |
| PHILIPS | 32PFL4007D/78 | Doesn't start. no LED lights up | 5v2 power supply a little weak. replace without testing: c9303, c9304, c9313 | Eletrônica Cecé. Brumadinho MG | |
| PHILIPS | 21PT8467 | It looked like a tube, retrace lines appeared and the protection was activated, turning it off. | C2465 electrolytic of 10uf/250v, replace it with one of 22uf or 47uf otherwise it won't work | C2465 swap | Alextecnico |
| PHILIPS | 32PFL3404 32PFL5604 | TV doesn't turn on, no LED signal. | Capacitors ch1 ch2, transistors qh1 qh2 and fuse f1 burnt. | Replace components. the capacitors are 221k 1kv, the transistors are k3568 and the fuse is 3.15a. | Darci Denzer |
| PHILIPS | FWM462X | Doesn't start | C772 220mf | E Cobra | |
| PHILIPS | 42PFL5008G/78 | Does not turn on or turn on standby | Power supply at the 5v voltage part of standby 0 | Ic 9801 r2a20133esp damaged and the mosfet q9802 ntd4906nt4g measures good but does not dock, replace directly and run to the hug | JORGE ASSISTÊNCIA TÉCNICA COTIA SP |
| PHILIPS | 32PFL3018D/78 ENVISION | When changing the main board the image was inverted. | The mainboard memory was from tpvision | I entered the code on the control, 062598 + home(menu)+164+ok, the TV turns off and on with the normal image, I didn't need to enter service mode | Geraldo de Petrópolis, RJ |
| PHILIPS | 42PFL4007G/78 | The logo appears and the backlight remains on, but it does not accept functions, it remains locked. | Software update - download link --- > http://zipansion.com/vodo wait 5 seconds and click on close advertisement, after downloading the zip file, unzip it, put only the update file "" upgrade_loader on the pendrive. pkg "", turn off the TV and insert the pendrive into USB 1 preferably, turn on the TV and a "software upgrade" message will appear, just wait for it to update and remove the pendrive once it's ready. | EC | |
| PHILIPS | 29PT8422 | The moment it turns on, a high-speed screen comes on with video and the sound then turns off. | I made a slight acceleration in the fencing, it took longer to turn off, and I started to have poor focus. | Defect in the tube socket focus. | Ademir tc |
| PHILIPS | 32PFL3008 | Doesn't start | On power supply: 9101- fet10n65, photoacsoplador i9102- 817, i9103-431, i9101- 2c110 | Eletrônica Cecé. Brumadinho MG |