Search: PHILIPS
Results: 14174

PHILIPS Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
PHILIPS29PT4643/78
The TV has heating on the horizontal output but has sound and image and is without contrastI need helphr santos
PHILIPSGL 1032
Dead (where there should be 70v there is only 1v and the capacitor is full)Ts321 (bc548)Replace with bc547VSE Eletronica(Adrian)
PHILIPS20PT3336/78
L03.6L
Vertical closed on offR.3448CompletedE. MATOS
PHILIPSFWM371
No audioTrans. q705 swap itReplace trans. q705 bdw94celetronicaapolo
PHILIPS29PT8422/78
Doesn't startNo standby voltageReplace tea1506t e resistor r3536 (2k2)Persio-TVCOMPANY
PHILIPS14PT218/78R
Turns off after 10 seconds after being turned onOne of the channel change switches was not working, I replaced it with a new one and the TV was normal, then I realized that there was a resistance between the two terminals of the switch. Note: whenever you notice that a device no longer changes the channel or increases the volume on the television panel, change the contact switches as they can create internal resistance, causing very complicated defects.fabiusmax
PHILIPS29PT4647/78
Horizontal wanting to close giving two black stripes on the side.Altered c2455 capacitor (47uf -25v)Replace c2455 without measuring c47μF -25vEletronica Som & Imagem
PHILIPS37PFL5332/78
Turning off01 of the 04 photo power supply coupler leaking.Daniel electronica solÂnea pbDaniel Felix
PHILIPS21PT5433
No image with audio/screen offBy slightly opening the skew you can see the softly reddish screen with return lines (retraction)The cause of the problem is the open 100k 3442 resistor, replacing it and readjusting the skew, the TV returned to normal operation.WAGGUINHO
PHILIPS29MT4515
Bulged sidesResistor 3411 ( 4r7)HP ELETRONICA
PHILIPS14PT3336/78
When turned on, no color and then turns off, showing a vertical lineMicroReplace the computereletronicapolo
PHILIPS21PT5433
LO3
Hoarse distorted soundErased memoryI replaced it and the TV went back to normalThis email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS20PT3331
3 colored lines when turned on, top of the vertical closed and then turned off1r resistor on pin 4 of the fly back (3446) open or alteredHP ELETRONICA
PHILIPS29PT4647/78
LO1.AL AC
Does not turn on and the stand-by LED is offCircuito drive horizontal irregularCapacitor 2455=47u/25v with altered capacitance. also replace the transistors: 7461 and 7463 - bc337/327.fastecel
PHILIPS29PT4635
L01.1L
It's just drizzling (different drizzling than when it's out of tune) and it seems to want to tune in but can't.Uoc 7200 (tda9583h/n3/3/1834 - processor)Tec vídeo
PHILIPS29PT552A/78
LLS
Burning1508dxC2460 no driver horizontale.matos R.S
PHILIPS20PT324A
Closing flashing image. When turning on the image comes back to normal after a few minutes on it starts to close the intermittent image, varying the width of the horizontal lines, sometimes also forming an intermittent and bright streak in the middle of the screen!47uf/250v electrolytic capacitor 2409 near flybackGEMASI
PHILIPS21PT5433
Vertical, top of screen closedDiodo 6460 / bas316Replace the same; replace also cap.2463eletronicaapolo
PHILIPS14PT3131/78R
***
Turning offMeasuring all the smd transistors of the power supply, I released vertical, horizontal and sound output and the defect continued, then I released q7541 and q7551 and the TV in the same way. and I adjusted the vg2. the TV worked normally.Loosen the transistors q7541 and q7551 to activate channel+ and adjust vg2.wagner
PHILIPS29GX1895/78R
Warming up horizontal outlet bu 1508dxCat made on top of the hot oscillator. n 7840 bd136Replaced bd136 and bu1508dxvicena