PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14174
Results: 14174
PHILIPS Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS | DVP3124 | Drawer does not open or takes time to open and cannot read the disc. | Change the spindle motor that turns the disc. | If after installing the motor the disc still does not rotate, place a 1r resistor from pin 12 of the am5888s to the negative of the spindle motor. That done, problem solved. | ELETRONICA SÃO FRANCISCO This email address is being protected from spambots. You need JavaScript enabled to view it. |
PHILIPS | 29PT8457 | It started showing a sentence on the screen, medium voltage, low and then went out, becoming completely inoperative | After changing the (tcet 1103g photo-coupler) it worked normally | c@rlinhoselectro | |
PHILIPS | 29PT4631 LO1.1L | 3 rgb lines at the top of the screen | Capacitors 2252 and 2253 | Just remove it and test | SIMAS433 |
PHILIPS | 21PT5433 | Top of vertical partially closed | Replace the polyester capacitor c2460 =82k/100v or 82 nonoparaids for 100 volts, as a precaution also replace c2446,c2465,2444,2463. | But in this case the main defect was the c2460 with loss of capacitance causing the TV to produce this defect | This email address is being protected from spambots. You need JavaScript enabled to view it. |
PHILIPS | 20PT3331 | TV with the upright partially closed on the top | Bad electrolytic capacitor c2465=10mf x 160v | Replace it, and as a precaution, also replace the capacitors c2446,2444 = 470mf x 16v because if they are filtering little, this will cause the capacitor c2465 to be stressed to the extreme and thus causing this defect | This email address is being protected from spambots. You need JavaScript enabled to view it. |
PHILIPS | PT123A | Does not oscillate. When pressing the channel key, the LED flashes several times and remains on standby. | Capacitor 2448 (47x160) e fly back. | Tec Video | |
TV PHILIPS | 14PT3131 LO3 | Vertical closed from the middle down and without sound | Erased memory | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
PHILIPS | 29PT4631 | Turns on and after a few seconds turns off. | All it took was a small increase in the screen to solve the problem. | Persio | |
PHILIPS | 14PT 314 A/78 CHASSI L9 2A | Turns off every time you turn on the antenna | Diodo 6413 bzx79-12v | severino alves | |
PHILIPS | 29GX1898 | Dark screen, when increasing screen return trace without osd | 4 | josé gusmão | |
PHILIPS | 20PP3336-78 | With menu sound dark screen | Replace resistor r442 100k | odair | |
PHILIPS | 21PT4656 | TV with backlight without sound and image, does not adjust brightness | Cause r3442 open | luismar | |
PHILIPS | 14GX1618/78R ANUBIS - VA | TV doesn't turn on | Led on, only on standby, hcc voltage at 1.95v | Transistor 7423 is good, but when I replaced it, the TV turned on again | odivaldo araujo |
PHILIPS | 29PT4635 | The vertical heats up and burns | The vertical one was broken, I changed it and there was a c25v 47uf dry capacitor, I changed it | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
PHILIPS | 20PT529 | Doesn't start | 7522 supply smd transistor | aedo | |
PHILIPS | 21GX1669/78R GR6-AL | Dark screen with sound when opening it writes, it lightens very little, no characters appear | Replace eprom | Schulz | |
PHILIPS | 20GL1041 | Low power supply | Replace transistor ts355 | Moraes sptv | |
PHILIPS | 20PT529A/78R **** | Low sound at maximum volume. | Capacitor c-2883 | Replace directly without testing. | wagner |
PHILIPS | DIVERSOS T/GL VáRIOS | Retrace lines and dark cloud-like screen at the bottom of the screen. | Clean the glue between the vertical capacitors and the chassis. They are to the left of the flyback or tsh. | Conscerta | |
PHILIPS | 29PT4635 | With retrace lines and then turns off | Ci code. 7330 is the tda 6107jf | I found that it had a voltage of +- 200v, even so there were traces on the screen, just replace it! | caio |