PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14168
Results: 14168
PHILIPS Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS | 42PFL5403 | Does not hit the relay, starts from stand by to turn on but does not hit the relay | Lack of main drive | Ground the standby which will hit the relay then press channel + and the TV will turn on. | ANDREI LOWE |
| PHILIPS | 42PFL3507D/78 | Power supply inoperative. primary power supply ok, but no voltage at the outputs and no standby. | Capacitor c9353 (330uf x 16v) with changed value and capacitor c9354 (470uf x 16v) shorted. | Replace the two capacitors. | Pixel Assist |
| PHILIPS | 20PT3331/78 | Short fly-back | Fly-back | Replace o fly-back jf0501-19255 | Sinailson furtado |
| PHILIPS | 32PF3403/78 | TV won't turn on dead power supply without 3.3vsb | 2.2uf smd capacitor in position c908 and the 431l smd transistor in position ic951. both shorted | Replace them and give power to the TV. | Francisco Melo - Parintins-Am |
| PHILIPS | 55PFG5100/78 | When turned on, the normal logo appears and when you place any signal on any input, the image appears bluish. | Software contamination | Enter the menu and give factory mode (reset) | SANTOMEL |
| PHILIPS | 32PFL3017H/12 | Does not turn on, LED is off. 5v standby voltage becomes about 2v | 330uf/16v capacitor c9353 in the standby power supply (if you measure it, it will appear to be normal) | Replace with a 470μF one | helderasf |
| PHILIPS | FWM653/55 | Standby does not turn on, shock opened CD board | Resolved | Carlos A Silva | |
| PHILIPS | 20PT3336/78 | Turns on and off in seconds | Cold solder on the smd resistors next to the flipback | Resolder all SMD close to the flyback. | MARCONES DE ARARIPINA-PE |
| PHILIPS | 32PFL4606 | It would start making a hissing sound like it was audio without an antenna and it would turn off | I released the speakers and the hissing noise remained, it was a high voltage leak. | It was the transformers, one was leaking internally, as tsound was an inverter board, I replaced the entire board, it solved the problem. | edmilsonpimentel |
| PHILIPS | 20PT3331 | LED comes out of stand-by but does not work | Several cold welds on the processor | AMERICO BREJO-PE | |
| PHILIPS | 40PFL3606D/78 | It didn't turn on completely dead. | Damaged components, fuse (f101), transistor (6n80c) replaced by k13a65d, and (c502). | Mkps | Marciok mkps |
| PHILIPS | 42PFL3605D/78 | Power supply does not turn on, does not output 3.3v, | 10k/1kv c120 with leakage | Replace c120 | Gabriel GXP |
| PHILIPS | 32PFL3606 | Doesn't start | Tsound is only 3.3v at the power supply | Cause, capacitor shorted next to the coil (dc dc converter), 2105. (thriller motherboard). ci 7122 heated up. | Maurilio |
| PHILIPS | 43PFG5100 | No image, backlight on | C103 | Remove or replace capacitor c103 on the display board | FABRICIO |
| PHILIPS | 21PT9467C/78 | Replace 220k 626 resistor | R 626 220k changed or opened | Replace 220k 626 resistor | eletronica global chiquinho |
| PHILIPS | 32PFL3404/78 | TV doesn't turn on | This TV has a system that is as follows: if you turn it off using the control, it will only turn on again through it and if it turns off using the power button, in the same way it will only turn on again through it. | Connect with control | Antonio Carlos (Eletrônica Renascer) |
| PHILIPS | 32PFL3606D/78 L11M1.1L LA | Noisy backlight and the inverter turning off | R41 (68k) open | Replace of r41 (68k) on the inverter board, it is close to the frequency adjustment potentiometer | leitemarcellus |
| PHILIPS | PH14D | No power supply/turns off/sometimes with sound | Resoldering at the power supply and replacement of the three trc board (all)q531a/b/c | Diagram(scheme)# | Gerson |
| PHILIPS | 21PT9467C/78 | Short fly-back | Fly-back | Replace the bsc29-3807f fly-back, yes, you don't have this fly-back, replace it with the bsc25-n1594 from the semp 2134 TV and just run for a hug. God be praised! Serto's semp 2934 fly-back also references the bsc27-2222 fly-back. | Sinailson furtado |
| PHILIPS | 21PT9467C/78 | Fly-back hole leaking high voltage | Fly-back | Replace the bsc29-3807f fly-back, yes, you don't have this fly-back, replace it with the bsc25-n1594 from the semp 2134 TV and just run for a hug. God be praised! | Sinailson furtado |