PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14168
Results: 14168
PHILIPS Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS | 14PT4131 | Turn on and off | Change smd diode 6460 and 6464 near the vertical transistor | DJ PITUKA | |
| PHILIPS | 42PFL3507 | Does not turn on completely inoperative | Capacitor seco | Replace c9353 power supply board | T.CUNHA |
| PHILIPS | 43PFG5000 | Does not turn on inoperative dead power supply due to a raw | C477 shorted on main board | Replace it and that's it or leave it without | orlando lott |
| PHILIPS | 29PT5642 | Cup effect | Data loss | Rewrite eprom | eletronica bianca ipira-ba |
| PHILIPS | 47PFL7008G | LED lights up and goes out. jam power supply to/test backlight | R-100Ω on pins 2 and 4 (gnd1 and stb) and jumper pins 3, 11 and 13 (3v3s - blon - dim1 ) | Back light coming on, confirmed that the main is bad | INOVA |
| PHILIPS | 14PT414 | TV without sound with normal image | Check a round fuse in position 1571 near the 1000/35v cover. This power supply goes through this fuse, from tsound it goes to the 2200/35v cover, follows the track, goes to the sound ci cover wsound it feeds it. | Replaced the fuse, gives normal sound. fed the sound ci. | <small>This email address is being protected from spambots. You need JavaScript enabled to view it.</small> |
| PHILIPS | 42PFL3605D | No image with screen on and the 12v voltage on the display popping up even after turning off the lvds flats | 750k resistor (7503) close to the 1m20 connector that goes to the keyboard, but under the board | ADEMAR | |
| PHILIPS | 21PT6458S/78R | Missing one of the colors i.e. missing blue missing green or red | Change all the RGB transistors that are on the tube board without testing | When changing the transistors, put new ones, and place it away from the board. | Luan LG Philips |
| PHILIPS | 29PT4635/78 | Jagged image when turning on and then off. | C2455 dead | Replacement | Delfran Eletroeletronicos |
| PHILIPS | 32PFL3008D/78 | TV only turns on the black light and turns it off | Flash memory | Remove the memory from the board, clean it and return it to the board, this may solve it, if it doesn't, replace the memory. | DJ João |
| PHILIPS | 32PFL7606 | Dark blue screen no image has sound | Leaky capacitors on the v-com board | Replace smd capacitors | cleberlima rs |
| PHILIPS | 21PT5435 | Don't call, sometimes you do! | C2524 2.2 100v burst or leak | Replace it and that's it | orlando lott |
| PHILIPS | 20GL1049 | The TV turned on, showed the image, menus acting normally with universal control, but the volume was at maximum and wouldn't go down. | It was thought that it was a bad memory. However, a jammer was found between the numbers 3961, 2605 and 9971 on the plate, which had one side loose due to rust. | With the resoldering, turning on the respective track that passes through it, when the TV turned on, the volume control worked. God is faithful. | <small>This email address is being protected from spambots. You need JavaScript enabled to view it.</small> |
| PHILIPS | 20PT3331 | Without image, with sound and characters appearing | Resistor r2442 150k next to the open fly back | Replace and run to cocoa | digital system |
| PHILIPS | 40PFL7606 | Turns on, backlight turns on but tsound is no video...normal sound | This email address is being protected from spambots. You need JavaScript enabled to view it. | I reflowed the main board processor and started it at 200 degrees and then a minute at 300 with a rework station..it went back to normal | Fabio Marinelli Eletrônica |
| PHILIPS | 32PFL5604 | TV turns on without backlight sound ok note; When turned on, a faint glow appears and then goes out. | Defect in the cf1 221k 1kv capacitor at the power supply with leakage. | Replace it and move on to another. | celso |
| PHILIPS | 29PT4631 | Relay knocking | Power supply oscillating voltage | Optical coupler replaced, just replace | RobertoBrujaH |
| PHILIPS | 32PFL3403/78 | Inoperative, blown fuse, | Bd 1, change the 3.3v fuse ok, when the power is activated the fuse blows again. | Test bd 1 out of circuit | Krul |
| PHILIPS | 43PFG5100 | Screen lit with no image and no sound | Capacitor c218 shorted on the left ruler of the screen | EDMILSON | |
| PHILIPS MAGNAVOX | 20MT2131/78 | Won't turn on normal 95v | Horizontal exit | Replace transistor bul312fp | Nilmar NVS |