Search: PHILIPS
Results: 14169

PHILIPS Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
PHILIPS14PT-4131
Turns on makes a square on the screen and turns offChange photo coupler transistor bc-547 of the power supply and 13k capacitor connected to the collector of the horizontal output.Ademar - Videira SC
PHILIPS21PT5433/78
When you turn this TV on, a pinkish image appears with retrace lines and turns off, if you turn it on again, it displays a dark image and sometimes makes a noise in the sound, leaving the technician with many doubts.Change the filament resistors (r3443 and r3444)consert's - assistencia tecnica
PHILIPS21PT9467C
Dark band under the screenR 310 e c 316Replace the 4 components c315 c316 r301 r309luiztvsom
PHILIPSAZ 1101/01
Only the CD and tape were working, the radio was muted.Cold solder the power supply components near the headphone jack.Marcio Magalhães Eletronica
PHILIPS29PT4635
Burning horizontal outletDiode,6460 picklejps, eletr,c,grande
PHILIPS21PT9467C/78
Totally inoperative. LED doesn't even light + b with 169vts. other secondary voltages do not exist.D610 shortedTonicoBH
PHILIPS29PT4631
It has all voltages, it oscillates, everything is ok but it does not generate any voltage on the fly backBu 4508 short only the base with the emitterReplace the bu and check the 1,600 v capacitorkin
PHILIPS14PT218A/78R
Takes time to turn on or works intermittentlyCapacitor 2411 (47mf/25v) with capacitance lossReplace c2411 with 47mf/50vsamuel leite
PHILIPS29GX1895
Tsound is only audio with the volume at maximumVolume controller boardVolume controller board (it is next to the microprocessor)LUIS CARLOS
PHILIPS20PT3331
It turns on normally after approximately 30 seconds, closes the panel and turns off, sometimes it takes a little longer.PhotocouplerReplace directly and if the capacitors are studied, replace them too and then just run for the hug.Danieleletronica
PHILIPS42PFL3403
No image with soundC236 (2200x25),c235 (2200x25) swollen and broken solder on the inverter pinsReplace and store graveleletronicaeltec
PHILIPS21PT6456
Turns on and then turns off, if you leave it on, it stays onZener +33 voltsChanging the zener, even when measuring correctly, for some reason causes an overload on the +160 volt linedeuner
PHILIPS29PT552A/78R
Baypss LED won't turn on flashingCapacitor 2575 100n that goes to ground in the optical coupler in shortReplace the same okosmar
PHILIPS14PT 3131/78
Does not turn on or the LED lights upC - 2564 (47uf/160v)Replace the sameBARRETO CRUZ
PHILIPS20PT4331
Reduced image at the top and no sound.Replace do c-7465 (10mf/160v) do vertical e c-2444 (470/16v) do audio.halbert_tec
PHILIPS20PT3336/78
Vertical; when turned on, a colored rgb band appears at the top of the screen, the screen lights up with a black band at the top and turns off.Polyester capacitor 2460=104 250v next flyback it changes and lowers 22v supplyReplace for newbeto2828
PHILIPS21PT9467C/78
It takes time for sound to come out. normal image.C629 2200ufx16v close to the power supply transformer.cecé eletronica
PHILIPS14PT212A
The TV only has standby on when it turns on with control, the stand bay turns off and turns on againCi tda9302h verticalReplacementsamuel abrantes
PHILIPS20PT3331
78R
With normal audio dark screenC 2444 - 470/16vReplaceMauro Mascarenha Parazinho - Ce
PHILIPS20PT3331
78R
Dark screen with normal audioC 2444 - 470/16vReplaceMauro Mascarenha Parazinho - Ce