PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14169
Results: 14169
PHILIPS Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS | 20PT3331 78R | Dead | R3445 resistor fusivel | Replace | Mauro Mascarenha Parazinho - Ce |
| PHILIPS | 20PT3331 78R | Dark screen with audio | C 2444 - 470/16v | Replace | Mauro Mascarenha Parazinho - Ce |
| PHILIPS | 29PT5645 | Turns on, RGB stripes appear in the middle of the screen, then an image with retrace lines appears at the top. | C2465(10uf x 100v) with low capacitance and cold soldering on some uoc pins. | Replace c2465 e resolder or uoc ci 7200 smd. | Rondinele Campo Redondo/RN |
| PHILIPS | 14PT314A L9SS | Fails, runs away color | When you touch your hand to the crystal(palm) color comes out | Ground the crystal body (the shielding} | jasvan souza |
| PHILIPS | 21PT8467 | With dark screen 8sg turns off | Capacitor g2 | carlinhos100 | |
| PHILIPS | 20GX1650 ANUBS | Black bar on the right side and heats the horizontal | Polyester capacitor c 2444 open or cold sound | Replace the c 2444 | cetrel eletronica |
| PHILIPS | 20GL1015 GR1VA, RO3, L1 | Does not turn on, LED dimly lit | +16v with just 5v, and memory pin 8 with 2.5v | 220μF electrolytic +16v slightly altered, replace | jasvan souzaq |
| PHILIPS | 14PT314A L9 | Blinking led | 3400 broken | carlinhos100 | |
| PHILIPS | 14PT3331 | Turning off only in av | After testing some components I didn't find anything but I already got this defect when turning off it was the CI that does everything | As this time I didn't have the CI that does everything, I disconnected pin 36 xrai and it was ok | Evandro/sousa.Astel Eletronica |
| PHILIPS | 21PT9467C/78 SK4.1L | When it turns on, it just makes a noise from the relay and tsound is no image or sound | Flyback raised the voltage in the vertical and burned the d303, d304, c315, c316, ic351 and in the power supply circuit of the rgb r318 and d305 | After changing the flyback xt bsc29-3807d I noticed that after a few hours on the image tsound was a windshield effect in the center of the image (pulled to one side) I put a shim on the ferrite and it was normal. | Helio(Eletrosonic) |
| PHILIPS | 21PT6456/78 | |no color | Color system does not appear in the menu | Enter service mode by typing 062596 on the control + menu > options > op > enter 000. | Evandro Estrela |
| PHILIPS | 14PT218A 78R | Burning d6405 | Change vertical output (tda9302) | jayjunior | |
| PHILIPS | 20PT3336/78 | After about 5 minutes on, reduce the width on both sides. | Capacitor c2408 (apparently good) 560n defective | Carlos Maia | |
| PHILIPS | 20GL1049 | TV works - has audio without image | Tube socket | Replace | EMERSON RIBEIRO |
| PHILIPS | 107S6 | Turns on and off without stopping. contrast messages appearing. | Full of poor contact, including on the tube plate and defective microswitches. | Re-solder the board and replace the four keys. | bimladem |
| PHILIPS | 29PT9457 L07.1L | Dead power supply | No 140 volts and secondary power supply does not work | Replace coupler photo | jedvaldo |
| PHILIPS | 14PT314A | Image shifted to the right black band on the left side without OSD | R-3404 | Replace 12k r-3404 | ladmyr eletronica universal |
| PHILIPS | 14PT3131 L03.1L | Pulsating power supply voltage dropping | Ci.7520 - photo coupler | REDELVIM | |
| PHILIPS | 20PT4331 78R | Does not work-dead.low voltages. | ET8011 photocoupler. in the cold test it was fine. but when changing it the TV worked. | Replace. I put the pc 817. | Rondinele_Serviço Especializado Semp Toshiba_Campo Redondo/RN. |
| PHILIPS | 21PT5433 78R | It's peppery | T 7466(smd),t 7463(bc 546) e r3445(1r). | Replace these components. | Rondinele Serviço Especializado Semp Toshiba Campo Redondo-RN |