Philco TV Repair: Common Faults and Solutions.
Search: Philco
Results: 4740
Results: 4740
Philco Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILCO | PCS2976 | R919 20k amended | amsmariano | ||
PHILCO | PCS 2952 | TV with the frame a little closed as soon as it turns on, as soon as it tunes a channel it folds horizontally and the tune goes out. | W. 720 47/25 from power supply +9 | Benê-Nepomuceno MG | |
PHILCO | TP 2010 PCI016A | LED wouldn't turn on, blinking with a small power supply crackle | Resoldar c-921 smd e x 301 | eletroléo | |
PHILCO | TP 20V56 | Sem audio no av | Exchange i.c 490 | Replace i.c 490 | This email address is being protected from spambots. You need JavaScript enabled to view it. |
PHILCO | PCM1446 | No color | C153 no pino 33 do micro | Carlos Afro | |
PHILCO | PCS 2956 | Excessive high voltage, popping in the pacifier | Wide capacitor,c 706 and c 709. | jrmonitores | |
PHILCO | PCS 2956 | Rainbow effect | Vertical output, tda 8351 fits tda 8356 in place | jrmonitores | |
PHILCO | PCS 2956 | Didn't care | Capacitor c921 shorted, do not remove, replace with another of the same value | jrmonitores | |
PHILCO | PC2039 E OUTRAS | Retrace lines, dull | C 801 on the trc board | To replace | Ricardo segab |
TV PHILCO | TP-2052N | It doesn't turn on after heating, if the manual switch off doesn't turn on, just by the control, it turns off and on normally. | Change c708 c709 and zd702, and from the power supply only leave the smd ones if that doesn't work, also change the smd ones | Reginaldo_nobre | |
PHILCO | TP-1452N | It doesn't turn on when it turns on, it turns off the LED on the STBAY 8817, Joelton's friend | It was transistor q702 that connected the open horizontal driver coil | Replace the transistor blz it works again | marcos melo cascavel ce |
PHILCO | TP-1452N | Screen blown (retraces), +b 180v low. | C-719 shorted, replace it. | Ronan | |
PHILCO | 21PT9467C/78 | Vertical closed | Ic351/ tda4865aj, r309 /01r, r310/o1r, d303/byw36, d304/byw36, d305/ba158, j308/067r | ELETRONICA ARNI-LEOBERTO LEAL /SC | |
PHILCO | 21PT9467C/78 | Vertical closed | Tda4865aj, r309, r310, d303, d304, d305, j308 | Help yourself leave your tip | ELETRONICA ARNI-LEOBERTO LEAL /SC |
PHILCO | PCM 2044 CPH05 | It turned off as soon as you turned it on | Protection circuit acting. normal power supply and others as well | R714 1k8 replaced to more | odivaldo |
PHILCO | PSC 2976 | Disabling protection | Capacitor c715 | Pin 36 of the one chip of this device activates the protection when the voltage exceeds 3.6v to simulate the non-activation of this protection, place a 3.6v zener to set the voltage on this pin in order to check the symptom of the image, don't forget to turn it on the device in the series lamp most of the time the problem will be horizontal the biggest culprit is the c715 | eletrônica micro eeprom popular miltom |
PHILCO | TP2052N | Dead | R913, smd 220r | Replace | Ricardo |
PHILCO | PCS-2956 | Disarming for protection | The culprit for this problem is the vertical integrated circuit, even after replacing this integrated circuit, the device continues to trip | Check by disconnecting the pacifier if the high voltage returns to normal (with it connected the device does not oscillate) try disabling the protections to force the faulty circuit to be visualized | Miltom |
PHILCO | PCM1446 | TV doesn't turn on. | Zd904=30v em curto;abre r923=1 r. | It was replaced and it was... ok. | Armando da eletrónica só tv. |
PHILCO | PC2138 | Blurred image. | C725=4.7uf for 250v, without capacity (note); if this same capacitor is shorted, the screen turns white with trace lines and the TV turns off by itself. | In both cases, the same part just needs to be replaced. | Armando da eletrónica só tv |