Philco TV Repair: Common Faults and Solutions.
Search: Philco
Results: 4740
Results: 4740
Philco Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILCO | TP14U56 | Normal image then goes dark and there is only sound | Diode d 602 altered | This email address is being protected from spambots. You need JavaScript enabled to view it. BRUNONIKACIO@HOTMAIL | |
PHILCO | PC1444 CPH05 | Ugly image (no contrast) no sound. | Tda8361 with internal defect | Replace the tda8361 e5 | josé carlos |
PHILCO | PC1444 CPH05 | Image shaking, synchronization and missing color | Change cap 205. exhausted 2.2mf 50v | josé carlos | |
PHILCO | TP-2052N | TV asking for password, in my case it asked for password on channel 3. | Reset to memory. | Press the channel + and channel - keys and plug in for 15 seconds. | This email address is being protected from spambots. You need JavaScript enabled to view it. ELETRONICA SÃO FRANCISCO |
PHILCO | TP-1454 | Doesn't start | D-909 opened d-908 changed | GBS.Eletrônica | |
PHILCO | TP-1454 | Doesn't start | D-909 amended | GBS.Eletrônica | |
PHILCO | PCM1444 | Does not respond to keyboard commands | Cause:r713 (changed or opened) | Replace and resolve | jarbas santos |
PHILCO | TP2920 | Turns on, no image appears, and then turns off, goes into protection | Check +b 50v from the vertical ci should have around 42v on pin 3 vertical ci, if it is below this ci value defective. | Bruske | |
PHILCO | PH21B | Turn on the TV perfect image after a few minutes the image starts to lose its brightness due to this defect | In the abl but it is not, defect in the kinescope board transistor bf 423 with emitter collector leak | Replace transistor v 903 bf 423 | fernando timbauba PE |
PHILCO | PCM2044 | It doesn't have 95 volts | C911 220mfx160vols reset | juci | |
PHILCO | TP-2921 | Excess green color | Eprom reprogramming. and a correction: to enter the service mode of this TV, press menu on the control and on the panel at the same time and wait a few seconds. | FERNANDO | |
PHILCO | PCS2952 | Vertical closed | Ic601-la7833/c610-100/63v/d703 e r720-1r | Replace mentioned items | eletronicaapolo |
PHILCO | TPF 2130 REAL FLAT | My TV had the LED on when I pressed the power button and it went into standby mode | I replaced IC 601 (STV 9302 a) and resoldered the 936 resistor which was with capacitor glue | TV operating normally, I want to thank everyone for the tip and good luck | Jorge Luiz |
PHILCO | TRANSGLOBE B 481 | Low volume and noisy on all tracks | Transistor t 406 pb 6015 after changing all the electrolytics in the amplifier, and losing some cable wires, I took it out and tested it and it said it was good, I decided to change it, damn the old radio came back to life | Marcio | |
PHILCO | TP2054 | Sound just squeaks like failing, | Replace o capacitor c402 smd | Resolved | This email address is being protected from spambots. You need JavaScript enabled to view it. ...RAMINHO |
PHILCO | PCM2046 | Blinking led | Defect l701 open | jglopes | |
PHILCO | TP-2054 | Dull | Capacitor c727 shorted | Replace the 100n capacitor c727 with 100v | somprimos eletronica |
PHILCO | PCS 2956 | Doesn't start | Q 706 or q 707 | ITAN,PARELHAS RIO DE JANEIRO | |
PHILCO | PCS 2956 | Low sound | Ci tda 8843 pin 15 shorted | Replace tda8843 | ITAN,PARELHAS ,RIO DE JANEIRO |
PHILCO | PCM2051 | Turns on works normally, but when turned off it doesn't turn on again | C708 and c709 and to avoid return, replace c704 and c706 | José gusmão |