Philco TV Repair: Common Faults and Solutions.
Search: Philco
Results: 4740
Results: 4740
Philco Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILCO | PC1446 | Without generating, with voltages all normal and LED just blinking | R705 open from 560r | Ramiro Lima | |
| PHILCO | PC1446 | Generates and cuts after 10 seconds, only 300v remains, if you release the +b, on the deflector it generates normally. | Zd-703,c-708,c-908,zd-903.replace. | Ramiro Lima | |
| PHILCO | PCM1451 | Without generates and without +b. | Tda-4605-3 | Ramiro Lima | |
| PHILCO | PC1446 | Without generating but with the normal +b, the normal 20v, just doesn't reach the collector horizontal oscillator. | Tda-8360k-4x | Ramiro Lima | |
| PHILCO | PC1444 | Working with image, coming and going with drizzle without following the controls | C-719 almost dry 10mf- 350v. | Ramiro Lima | |
| PHILCO | PCM2044 | With image and sound, little brightness | R-813 aberto, 680k | Ramiro Lima | |
| PHILCO | TP 1452N | Voltage overload on a rainy day | D 901 short | Manoel Felipe | |
| PHILCO | TP-14N | TV with bad tuning, image with drizzle. giving the impression that the seletronic is defective. | Change mf201 seletronic if output filter. | Joacyr | |
| PHILCO | PCM-1446 | Stand by LED doesn't light up, doesn't turn on | Capacitor c932 | ||
| PHILCO | PCM 2952 | Protection mode | Wide capacitors | At first the flyback had broken, it was replaced and the TV wouldn't turn on. I turned off the protection and the TV turned on with no height and width and the horizontal output transistor burned out, it was the 6n8 width capacitors. tv ok | Eli |
| PHILCO | PC-20R38 | Dark image | C 725 open on the 180v line | AdrianChapadão | |
| PHILCO | 29C21 | Turns on and off after 3 seconds | Fly back | ||
| PHILCO | PCM 2146 CPH06 | Image aliasing in the middle of the screen approximately 5cm wide | Transistor q 702 with minimal leakage | Replace what | This email address is being protected from spambots. You need JavaScript enabled to view it. |
| PHILCO | PCS-2950 | Turns off intermittently, may take hours to turn off | Vertical output, check capacitors and ci | ||
| PHILCO | PCS-2956N | 'turns on but doesn't oscillate horizontally | Verificar c706,c708,c728 | Marcos | |
| PHILCO | TPF2971 | Turns on and after 5 minutes turns off and the stand by LED oscillates between green and red | C 805 with very short contacts (from the factory) and generating | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
| PHILCO | PCM-1444 | Stand-by LED flashing non-stop and the power supply | Replace o ic 601 (tda 3653) vertical | tony eletronica | |
| PHILCO | 1443 | It has all the voltages but it doesn't turn on | Micro clock crystal | Andrade Sequeira | |
| PHILCO | PCS-2952 | To eliminate flash that appears when the device is turned off | Remove diode d804 from pci board | Andrade Sequeira | |
| PHILCO | PCM-2046 | Does not turn off on the remote control | Q901, q904 shorted | Andrade Sequeira |