Philco TV Repair: Common Faults and Solutions.
Search: Philco
Results: 4740
Results: 4740
Philco Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILCO | PCR2049 CPH06 | Turns it on after a few minutes, it turns off or you turn it off, then it doesn't turn on anymore, it only turns on after a few minutes. | I verified that the horizontal output was experiencing unusual heat. | I replaced the 708 capacitor (471x2kv) and that's it. | Alvanyr |
| PHILCO | TP1453 CP02RO | Philco tp 1453 TV with a drizzled image as if high voltage was escaping and switching off intermittently, I changed the flay and cleaned the capacitors horz. | R-917 2k2 | Open replace do not measure on the chassis | Schulz |
| PHILCO | PVT1416 | Does not turn on, power supply drops voltage when trying to turn it on or placing a load | The power supply primary capacitors c504=47/25v, c538=1/160v | BRUSKE | |
| PHILCO | TPF2121 | Sometimes it doesn't turn on | Resolve diode d 907 | Tip from your cÉzar | JOHNN |
| PHILCO | TPF 2121 | Loud noise comes out of the speaker and protects LED keeps flashing | Diode d 909 shorted r911 r912 open | JOHNN | |
| PHILCO | PCS 2976 | Does not work at 110 vts | Replace d 918 | Get separated | ELIZEU RIBEIRO |
| PHILCO | TP-2052N 00000 | TV with bad tuning, image with drizzle. giving the impression that the seletronic is defective. | Filtro do if mf201 | I replaced it for one from scrap, defect resolved, hugs, I believe everyone is aware of putting their tips to everyone, professional friend | |
| PHILCO | PCM 1452 | TV was oscillating but the screen was dark, adjusting the screen, a squeak came on the screen with a deficiency in one color, it was all yellow | Ci one (oscillator) was defective, I replaced it, it solved the problem | ozanan | |
| PHILCO | TPF-2121C 00000 | Oscillates horizontally but after a maximum of 4 seconds it turns off, and the LED flashes; | Capacitor of { 6n8 1k6} as low capacitance ; | I replaced fixed braces blz!!! tec friends who are aware put their tips because everyone needs a tip shelter everyone | marcos melo |
| PHILCO | TP2054 | This TV was turning on but with no image, just a line in the center, I thought it was vertical and it wasn't | 917 resistor without soldering at one of its ends, after re-soldering the TV started working normally again. | Moizes | |
| PHILCO | PCM2044 | Fabric turns off intermittent. | C719 (10uf/250v) | Andrade Sequeira | |
| PHILCO | PCM2044 | Does not work. stdby led is blinking | Shorted ic 401 (tda2613) | Andrade Sequeira | |
| PHILCO | PCM2044 | Doesn't work | Zd901 is shorted.replace str50103. | Andrade Sequeira | |
| PHILCO | PCM2044 | Dark screen | R716 (10k) | Andrade Sequeira | |
| PHILCO | PCM2044 | Turns off every 5 minutes | D301 e d302 | Andrade Sequeira | |
| PHILCO | PCM2044 | No contrast | C716, r706 e r717 | Andrade Sequeira | |
| PHILCO | PCM 2044 CPH05 | When you increase the brightness, the TV turns off | Zd703 leak | Filipe | |
| PHILCO | PCM 2044 CPH05 | When connecting an antenna, the TV turns off (protection) and when the brightness increases | Leaky dz-703 (power supply) | Luiz Filipe | |
| PHILCO | PCS 2956N | Power supply does not weapon | 470uf Dry Low Supply Condenser | Elizeu | |
| PHILCO | PC2027U | The power supply had a sharp and loud hiss. | C911 -> 4,7uf/160v. | This email address is being protected from spambots. You need JavaScript enabled to view it. |