Philco TV Repair: Common Faults and Solutions.
Search: Philco
Results: 4740
Results: 4740
Philco Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILCO | PH21 MS | Totally dead, don't care | Capacitor c817, short. | Replace c817 331. | javier |
PHILCO | PH21MSS | +b from 108v, dropped to 92v. | 27k r832 open! it grounds pin 1 of the tl431. | Just replace it and everything goes back to normal. | JLS Eletrônica Belém PA |
PHILCO | PCA660 | Does not read CD/DVD | Media loading limit switch on the CD plate with very high resistance | Clean or replace it | jheliocavalcanti |
PHILCO | TP-2054 | It doesn't tune channels or AV, tsound's a dark drizzle wsound it should tune the channel, the same thing on AV. | Ci does everything ic101 faulty. | Replace the ci, taking care to check if it is really from (tp-2054), the one from (tp-1454), although it has the same screen printing, does not work correctly. | Edfesom |
PHILCO | PH28N91DSG | TV with symptom as if it were the LED, but when checking the LEDs they were ok | I replaced capacitor cw23 and cw27, both 330uf 35v | Eletrônica Ideal | |
PHILCO | PH32E32D LED | Various symptoms, time turns on, no sound, hangs on the philco logo. When it doesn't matter, it's just on Stanbay. time turns on and the dashboard LEDs do not light up | I checked the power supply, the memory | I noticed when I heated the motherboard with the thermal blower the TV turned on normally when it cooled down the TV stopped and the symptoms started as I described. I started heating the capacitors on the motherboard and one capacitor in particular when I heated it the TV worked normally and I removed it to measure 100μF/16v volts it had a low capacitance of 47μF. I replaced it with 100μF/25v and the TV started working normally again. | Adriano Miranda |
PHILCO | TP-1453 | TV said it was going to start and turned off quickly, +b voltage with 141v normal 110v. | R919 precision resistor 1% of 120k measuring 134k. | Replace the same. (edfesom varjota-ce) | Edfesom |
PHILCO | PH14D | It only turns on after a few minutes in the socket (after it warms up) | After spending a lot of time changing capacitors in the primary power supply, I discovered that the defect was in the 2n5551 transistor. | I just replaced the 2n5551 and the TV started right away | J.S ELETRONICA (Nilsinho Rodrigues) |
PHILCO | PH-32E31DG LED | Turns on the LEDs and turns off immediately! | Capacitors c2d7, c1d9 c2d6 both 100uf x 50v. is high or puffy! | I replaced them all and the TV worked. normal. good luck! | EvandoViana |
PHILCO | PH-32E31DG LED | Burning LED bus. | LED bus voltage above 42v. | Remove resistors r2b2 and r2b5 from 0r. the voltage will drop to 42.5v | EvandoViana |
PHILCO | PTV43E60SN | Does not turn on back light | Remove qp411 close emitter collector on board remove capacitor cb6 | Remove qp411 close emitter collector on board remove capacitor cb6 | central audio e video |
PHILCO | PCM 2051 | This television played a trick on me, after I repaired it I tested it and released it, it went back to the workshop, just calling when I wanted, I suspected the c913 but I didn't change it because I tested the esr was good on capacheck and capacitance was ok on the capacimeter, I spent a long time looking for a defect wsound it wasn't I did, until the next day I decided to go back to the c913 when the problem appeared and heat it with the iron and the TV turned on normally. | C913 changes the esr only when it is cold or at room temperature, changing it without measuring, in my case I put a 2.2uf per 100v it was a gem. | Replace c913 (edfesom varjota-ce) | Edfesom |
PHILCO | PH40D10DSGW | Backlight turns on does not light up | Diodo dp401 | joão luiz | |
PHILCO | PTV32G50SN | Device does not turn on - inoperative | Recovery tcon board - type kb6160 - shorted capacitor | Ct842, ct843, ct844 next to the dt802 diode | Renan - Eletrônica Popular MT |
PHILCO | PHT10000 | Doesn't start | D-03 ss24 short | Replace | JORGE IVOTI |
PHILCO | PH21MSS | I'm sound | Rewrite the eprom | DJ PITUKA | |
PHILCO | PH21MSS | Does not turn on, generates and cuts | Change without measuring the transistor q 802,2n5551 | DJ PITUKA | |
PHILCO | PH21MSS | It doesn't turn on, the LED only lights up when it wants, and the power supply goes to 152v | Non-secondary diode replace d813 | DJ PITUKA | |
PHILCO | PH 21 US A1 | Retrace lines and width defect | Change all the swollen capacitors (this model usually has many) and replace the c568 (10ufx250v) | Baguatech | |
PHILCO | PH40R86 | Dark image | Changing the cw922 capacitors is the cw 908 | Bruno nicacio |