Philco TV Repair: Common Faults and Solutions.
Search: Philco
Results: 4741
Results: 4741
Philco Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILCO | 1452 | All button locked | To unlock, press all the buttons together with the TV turned off and turn on the TV without releasing the buttons when it has already been unlocked. | HAWAI | |
| PHILCO | TP-1554 | Turns on and off, LED flashes. | C 7015 | And just replace and run for the hug - | JUNGER |
| PHILCO | TPF-2940 | This TV arrived with the following defect, it turned on the stanby LED and generated high voltage and then the high voltage went down and the LED started to flicker. | The cause of this defect is the polyester capacitors c1701 and c1703 and just change them and move on to another TV... | diego lima nova timboteua pa | |
| PHILCO | PC 1441 | With sound, with characters and without image | Ver c-301 0.47uf | Master Eletronica | |
| PHILCO | PH400 | Does not turn on / no audio | Q1 e q2 mje13009 - r16 e r15 2r2 | Replace mentioned items | eletronicaapolo |
| PHILCO | TP-1453 | White screen with scratches | R711(4r7) d703-c719(470pf)-c803(470pf) | HP ELETRONICA | |
| PHILCO | TV-PH21M | Does not turn on, normal power supply | Building 804 (h, sv) | Digão Eletrônica Solar | |
| PHILCO | PH21B | TV with white screen full of scratches | I short circuited the 180v line | Back to normal | fco |
| PHILCO | TV PH21SS | Vertical closed at the bottom with half screen. | C 526 1000x25v, I changed it, it was fine. | Alvanyr This email address is being protected from spambots. You need JavaScript enabled to view it. | |
| PHILCO | PCS2700 | Does not turn on, LED goes off and comes on again, does not arm. | Exhausted capacitor c711 6n8 1k6 | Replace the capacitor | eletronicaf fox |
| PHILCO | PCS2952 | No color | Zd504 | Eletronica Millennium | |
| PHILCO | PH29M SS | Does not turn on LED blinks when pressing keys | Change the eeprom memory! | orlando lott | |
| PHILCO | PH 14D | When you plug the device into the socket, the LED lights up and then goes out, but the device doesn't work - and the + b is low (+ or - 45 volts) and in addition the c 835 takes a long time to discharge. | The person responsible for all this is: r835 10r open and q881 (2n5551) shorted. | Replace r 835 (can be metal film) and q881. I also used bf422 and it worked normally. | adhemar caetano da silva (tecmil eletronica) |
| PHILCO HITACHI | PC2035 | Fountain beeping | C910 and/or c925 sold out. | Check the capacitors and replace them. It is recommended to check the other adjacent electrolytics. | Wiliam7745 |
| PHILCO | PH 29 B | Closed image completely dark at the top of the screen until almost in the middle, at the bottom of the screen completely open. | C i ,from vertical,defective. | It was replaced and the zoom adjusted and it was ok. | Armando de Olimpia Eletronica EvoluSom |
| PHILCO | PCM 1446 * | Turning off with white screen with retraces on the screen | C-719 | Just your replace | wagner |
| PHILCO | PC-20R48 CPHO2 | Vertical linearity, stretched at the top | Electrolytic c613, 1000/25v slightly altered | Replace | jasvan souza |
| PHILCO | TPF 2940 | Burning r1703 dz1702 and q1701 | Bad contact cn1701 cn1702 solder directly, in my case I soldered them all, note; some technicians are reading q1701 as irf 1520 not getting the part, its specification is irfi-520n common mosfet | luismar.1 | |
| PHILCO | TP14U56 | LED on only turns off by pressing menu or + channel but it doesn't turn on anything on the other keys it doesn't do anything | Diode 908 | Replace d 908 | celito santo angelo |
| PHILCO | PH21M SS | Turns on standby, but does not turn on | Eprom memory, I replaced it with an already recorded one and solved it | MARCONDES LIMA,Jaicós-PI- Brasil |