Sony TV Repair: Common Faults and Solutions.
Search: Sony
Results: 20067
Results: 20067
Sony Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
SONY | PSLX510 | Incorrect ass'y number | Could not locate part number for stator assy. found on page27 the assembly is numbered 129. it should be 126. -hq comments: will issue a t/n and s/b. | ||
SONY | XRM10 | Very low, yet undistorted am band audio level | Audio ok coming out of am ic, but would not pass thru c-60 onam pc board. | ||
SONY | CFSF11 | No record | Pause is engaged before record. indicator lights but recordlinkage is not engaged. the record trigger lever is jarred off recordlever a (see p.10 of the supplement #1). -hq comments: replacement of forward lever is necessary. the problemcomes from th | ||
SONY | SL25 | No p/b or f/f functions | No f/f mode at all. would enter rewind mode whenever the p/bmode was entered. the sensor leads resistance would change from 4Ω to20Ω whenever the leads or the pc bd of the sensor was agitated. | ||
SONY | KX2501A | All blue raster, retrace lines, very low video level, q1302 | Crt raster was all blue with faint retrace lines and very lowvideo level. we were unable to reduce the blue level with crt or bright-ness controls. dc voltage checks allowed me to trace problem to a leakytransistor, q1302 on bd board. | ||
SONY | KP4600B | No green vertical sweep | With set on, there was no green and display bar (which wasblack), rolling vertically. system looks like a problem in the picturetube area, but found no green vertical sweep. with loss of verticalsweep, there is no horizontal line, because itclue was th | ||
SONY | SLHF300 | No power | Unit would not power up. replaced ic301 (timer) but ic wouldnot reset, so problem was not resolved. | ||
SONY | D5 | Blown transistors and ic (sled circuit) | Unit was brought in for service due to defective sled motorgears. upon inspection, we discovered that ic508 and q502-505 were burntseverely. the chip transistors disintegrated. ic508 is cracked and brownin color. | ||
SONY | BMC550 | Incorrect p/n page 148 | Typo in manual, page 148. -hq comments: correct p/n sk-3 board (complete) a-7060-078-a ds-10 board (complete) a-7060-098-a ds-10 board part number is correct on page 175 in the s/m. | ||
SONY | KV2602 | Only tunes low channels, replaced non sony q008 | Vc voltage at tuner would only go up to 10vdc. | ||
SONY | TCFX505R | Controller chips difference | When ordering ic501 and ic505, tc #9310n-032 (8-759-201-86)and tc #9310n-033 are sent instead of -021 and -022. the serial # showsthe unit falling into the former type but icalso fiche crosses to the new numbers. are the two compatible? -hq comments: | ||
SONY | KV2680R | Audio exists at vol zero, replace ic-1107 | When the audio level is turned all the way down, you can still hear audio. | ||
SONY | BMC550 | Replacement numbers for cr2025 battery | Since we do not have sample cr2025 battery, can you advise theduracell or eveready replacement numbers? -hq comments: the numbers are as follows: sanyo cr2025 duracell dl2025 | ||
SONY | KV1515 | No high voltage | No high voltage, +115v up to +142v. half of the dialindicators light at the same time. sometimes the tv would work normal. | ||
SONY | KP5040 | Cable interference, soldered tuner, prescaler and ant sw | Fine diagonal lines on ch. 4 spaced about one inch apart. | ||
SONY | ICF200W | Ref #503 and 504 reversed | Ref. # 503 and 504 reversed. should be + board a p/n 1-605-271-00 - board b p/n 1-605-270-00 -hq comments: we will issue a t/n and s/b. | ||
SONY | TAAX44 | Missing p/n | Page 27 of the service manual, location 2-a. per kc, thepart number should be x-4882-013-1. this part number is not given in theservice manual. -hq comments: the part number is correct. will issue a t/n and s/b. | ||
SONY | TAAX44 | Missing part number | No part number in service manual nor in semiconductor book.you issued hifi bulletin #166 (july, 1983). -hq comments: the part number is 8-759-100-43 as in the hifi bulletin#164 issued in march 1983. the mpu w/-200 has been changed to -213. | ||
SONY | XM100 | No audio output | No sound. found power amp transistors q411 in left channeland q512 in right channel shorted e to c. after replacing transistorsstill had no audio out. further checks showed +3v on both e and c of q302(remote switch). found r305, 100 kΩ res. open. | ||
SONY | KV1922 | Crescent moon effect | When set was first turned on, you have a full picture. witha crescent effect on the left side of the picture, it was about 12 incheshigh. after approx. 1 min., this dark area would fade and then thepicture went into a christmas tree effect with about 4 |