Sony TV Repair: Common Faults and Solutions.
Search: Sony
Results: 20067
Results: 20067
Sony Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| SONY | BMC550 | Part number for handle screw | We need the part # for the thumbscrew which attaches thehandle to the necessary shoe on top of the camera. the part number forthe handle is 3-691-167-01, listed under accessories at the rear of themanual. -hq comments: the handle is not available as an | ||
| SONY | TCM600 | Missing part number for stop lever | Need part number for stop lever, page 18 of the manual. -hq comments: the part number for the stop lever is x-3557-403-0. willissue a t/n and s/b. | ||
| SONY | KV25XBR | Ibm pc interface | The kv-25xbr service manual provides no technique or specifi-cations for adjusting the rgb subbrightness controls rv401, 402, 403. ifthis unit performs with the ibm computer, as did its predecessor theprofeel, adjustments may be necessary. -hq comments | ||
| SONY | STJX410 | Wrong p/n in s/m | 8-759-925-10 is tl510cp for but1000. part # should be8-757-925-11 per transistor sub book. -hq comments: the number is 8-757-925-11. we will issue t/n and s/b. | ||
| SONY | XR740 | Car stereo would blink on/off | Dealer was trying to install unit in mercedes with factorypower antenna. when unit was powered up, car antenna would extend to fulllimit, then car stereo would blink on and off and thumping sound could beheard through speakers. | ||
| SONY | KV1331 | Missing part number for bracket, 4-365-826-22 | Need part number for tuner bracket. -hq comments: the part number for the bracket is 4-365-826-22. thebracket is not currently in stock, will be available soon. | ||
| SONY | KV2670R | Buzzing in audio, r-211 cold solder | Servicer complained of buzzing on all channels, at timeslouder on some channels than others. while troubleshooting the set, inoticed that one end of r211 was not pushed through the hole on the pcboard. when i inserted the resistor in the circuit, the b | ||
| SONY | BMC110 | Intermittent no record | Customer complained that once tape was inserted, unit would gointo play mode. record and stand-by switches had no effect. also whenyou could get unit to record, edits were very poor due to insufficientbrake and pinch delays. during malfunction no leds | ||
| SONY | KV1910 | Hv block | Model kv-1910 uses hv block 1-453-046-00. according to micro-fische, it has been subbed to 1-453-070-00. both are not physicallyinterchangeable and it is impossible to use original parts from old assy.can hv block 1-453-062-91 be used? -hq comments: 1 | ||
| SONY | KV1915 | Audio out | No audio or intermittent audio on certain stations. manymodels (kv-1913/1914/1916/1917/1918) have the same circuit. | ||
| SONY | KP4600B | Picture would gradually collapse to a horizontal line | After several hours of playing, picture would graduallycollapse to a horizontal line. | ||
| SONY | KV5100 | Picture tube failure | New picture tube installed, then unit went dead. every timeconverter output transistor failed. fail within a couple of hours.servicer convinced problem not in power supply. proved dc operation ok.problem found to be dried out filtersand coupler capaci | ||
| SONY | KV2145R | Foldover at the top of the picture, r520 decreased in value | After warm-up, pix would start to pull down with slight fold-over at top of pix and r520 decreased to 7.8kΩ. | ||
| SONY | KV2670R | Unusual loss of vertical synchronization, ppu1a freq synth u | Random intermittent loss of video info. and vert. sync whichmay occur on any channel at any time. pix/signal quality also appearedweak on a random intermittent basis. | ||
| SONY | CTV | Distorted pix | When hooked up to cable there is a vert. bar approx. 1/3 ofway in along with ghosts of varying severity on ch. 4 & 6. a new broad-cast tower for these stations went into operation and has progressivelygotten worse. it is caused by ingress of the broadc | ||
| SONY | PSLX310 | Tracking problem | The unit would not track properly using a grado mf3 cartridge.we found the turntable to be working fine but incompatible with thiscartridge. | ||
| SONY | PSLX510 | Won't play all 45's | The tone arm would move in about two inches and then go backto the rest position. the diameter seemed ok but no warp. there was aslight taper at the edge. we resolved the problem by remounting thedetector diode so that it pointed at a 45 degree angle | ||
| SONY | CDP101 | Hiss on one channel, other channel dead | Left channel sound was fuzzy and covered with a lot of hiss.right channel was dead. pin 18 of ic507 (d/a conv) looked fairly clean.pin 17 (r-out) had a lot of noise on it. power supply of q505 had some noise,not present at power supply of q504. resistance readin | ||
| SONY | MLV1100 | Non-switchable of the line in signal at line out | When using line out to connect to amplifier or cass deck, the customer cannot get line in signal. he always gets mpx in signal. | ||
| SONY | STRVX250 | No memory | No memory. the segment of the fl display go off unevenly.the voltage at pin 42 of ic301 is as low as 1.5v instead of 2.4v. |