Sony TV Repair: Common Faults and Solutions.
Search: Sony
Results: 20067
Results: 20067
Sony Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| SONY | PSX800 | Tone arm malfunctioning horizontally | The tonearm did not center itself when it is up position.therefore the tonearm slide inward or outward becasue of the angle error. | ||
| SONY | CDP701ES | Noise in r ch | R-ch sounded very noisy. sounded like ju-ju. | ||
| SONY | CRF320 | Sound is low intermittently | When turning on the power switch with the timer function, thesound is very low. | ||
| SONY | WA55 | No fm | Am worked fine but could not switch to fm. | ||
| SONY | CFSF11 | Hum noise with ac-190 | When using the ac adaptor ac-190, a slight hum noise is heardthrough the headphone in the play mode, even when the volume control isminimum. | ||
| SONY | TCD5M | No play | There was no function, because the motor did not turn. | ||
| SONY | M7 | Hook-up confusion | Wiring diagram on page 16 of service manual can be confusingwhen replacing mike. | ||
| SONY | CFS3000 | Wrong rear cabinet | When rear cabinet is ordered by 3-319-547-01, part receivedwill not fit unit. the part, we need says made in korea on rear,whereas the part we are receiving says made in japan. could you supplyus with the correct part number for the rear cabinet of the | ||
| SONY | KV1747RX | Incorrect part number for module dm4 | Dm4 (ic601) part number given incorrectly in kv-1747rxservice manual (1-123-705-11). -hq comments: correct part number is 1-231-705-00. we will publishcorrection on this. | ||
| SONY | D5 | Unit shuts down | Disc would start, then quit. operating the unit upside downwould sometimes allow unit to play. once engaged in play, it would skiptracks intermittently. search reverse would not operate. | ||
| SONY | TCK60 | Irregular speed | Excessive w and f. static torque tests ok, motor and servocheck ok. rubber ok. | ||
| SONY | WMF8 | Incorrect p/n for switch lever | P/n for switch lever is incorrect. -hq comments: the correct sw lever for the wm-f8 is by p/n 3-319-028-01.please refer to the t/n a0046 for the p/n correction. this should fitwithout modification. the sw lever you received is for the tcm-6. | ||
| SONY | SL2700 | No function of pb or rec. no operation of motor circuits | Replaced fuse ps-605. -hq comments: the ss-14 board contains five fuses (3-glass tube type,2-semiconductor type). after checking the supply voltages at theconnector pins, it is a good idea to check all fuses. | ||
| SONY | SL3000 | Missing part number for frame button | Need part number for frame button on page 8-2 of sl-3000manual. -hq comments: p/n is 3-654-555-00 (qty in stock - 100). | ||
| SONY | D5 | Compact disc | Intermittent distortion. right ch. would also occasionallyincrease in volume, high frequency content would also increase. pushingon pc board would cause unit to exhibit problem. | ||
| SONY | ZX7 | Part number missing | No part number for m901 (capstan motor). | ||
| SONY | CDP302 | No play | Three units with the same problem. symptom was no play func-tion. found optical block stuck at rear of bu-1 unit, even afterreleasing transit screw. | ||
| SONY | KV25XBR | Vertical jitter | This unit had a 1/2 vertical jitter when using a satelliteantenna. on cable or regular vhf/uhf antenna, there was no problem. | ||
| SONY | BMC550 | Part number for imager | Bmc-550 irp 8-750-010-22 what is correct p/n for bmc-550 s/m 8-750-010-22 ccd-v8? we do not know and ccd-v8 irp 8-750-010-22 have no stock of s/m p/n. ccd-v8 s/m 8-750-010-22 -hq co | ||
| SONY | XR40 | Fm stereo failure | After 30-60 minutes, stereo light will no longer turn on ifstation is changed or mono/steno switch is pushed. radio still plays butin mono. switching voltage at pin 7 of ic2 is 6.9v with stereo switch on,7.8v with it off this remains the same whether u |