TV Repair: Common Faults and Solutions.
Search:
Results: 87420
Results: 87420
Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
SONY | TCW3 | Muting problem | Unit was muted on both decks. however, with deck a in playmode, pushing deck b play, ff or rwd buttons, unmuted deck a. pin 42 ofic303 was low. d317 is not in the circuit nor is the foil pattern whereit is shown. | ||
SONY | ICF2001D | No tuning fuctions, display goes to 150khz | Unit will not tune. display will get stuck at 150 khz. foundcracked c118 on pll. | ||
SONY | SL2710 | No tuner mode | Unit would not operate in tuner mode. channel indicator ledwould not light up and no picture on monitor. | ||
SONY | SLHF1000 | Pix distorted during self rec pb of computer signal | When recording off an apple iie computer, during playbackthe unit exhibits severe horizontal tearing. i contacted apple and foundthe iie operates at 15,700hz horiz/non-interlaced, and 59.92hz verticalfor the composite output. -hq comments: i checked th | ||
SONY | KV1961 | High pitch hum (int), jumper wire vibrating | Intermittent high pitch hum, loud at times coming fromlocation of flyback. | ||
SONY | KV2771R | Audio popping, replace c-140 on "a" board | This unit had intermittent popping in the audio. | ||
SONY | CCDV8AFU | Ps601 blows | Blows fuse ps601 on mc-4 board after 4 hours operation withac-v8uc ac pack. applying logic analyzer to e and b of regulator q619received a positive pulse on both elements when the fuse blew. | ||
SONY | CDPC10 | Low level hum | Unit puts out a low level hum, easily heard in play pause withvolume turned up high. | ||
SONY | SPP100 | Noise heard on handset | Customer complained he heard noise coming through handset.by disconnecting c416, it was determined that the base unit was transmit-ting a noisy signal. | ||
SONY | XR27R | Radio intermittently shuts off by itself | Bad solder connection on d525. the hole is too large for thelead size. the solder does not make total contact around the hole and thelead. | ||
SONY | SL2700 | Brake solenoid would not engage | Brake solenoid would not engage, brake solenoid opened.found problem to be a leaky switch (q332) causing forward bias on q309. | ||
SONY | CCDV8AFU | Scrambled pix | Intermittent scrambled pix. could hear rattling in unitwhen moved. | ||
SONY | CCDV8AFU | No video rf | No video out on vhf-rf. | ||
SONY | CCDV8AFU | Eject led and noisy motor | When using ac adaptor, eject led flashes. motor noisy onbattery operation. | ||
SONY | CCDV8AFU | No record | Flashing eject led, will not stay in record mode. | ||
SONY | CCDV8AFU | Bad pix | Pix fuzzy on playback. eats tapes. | ||
SONY | CCDM8U | Bad playback | Bad playback. tape jamming. | ||
SONY | CCDM8U | Dark playback | Playback from recording darker than pre-record. | ||
SONY | BMC220 | Playback video | No video during playback mode. | ||
SONY | CCDV8AFU | Distorted pix | Picture distorted. |