Search:
Results: 87420

Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
SONYKV2084R
Channels not stable - problem with lock up, shorted q934The channels would take a couple of seconds to lock in and itappeared as if the unit was hunting. we found that there was no horiz.input on the upc - ic101/p.8. we traced the problem to a defective q934/horiz. sync separator on the u board.
SONYKV2071R
No remote functions, replace ic001 on "t" boardUnable to use remote functions. troubleshoot the a boardcould find nothing wrong. sircs signal looked good coming into pll cont-roller. changed a board did not resolve the problem. changed receiverdetector ic001 on t2 board, resolved problem. the on
SONYAVU270
No tv or videoUnit had no tv or aux video.
SONYCCDV8AFU
Lines in pixLines in pix.
SONYCCDM8U
Poor pix reproductionPoor playback picture.
SONYCCDM8U
ShutdownUnit shuts down.
SONYCCDV8AFU
No audioNot audio.
SONYXRA37R
No audio output from speaker outputsNo audio output.
SONYWM45
Intermittent speedIntermittent speed.
SONYCFS4000
DeadUnit will not power up.
SONYWMF41
Left channel headphone does not workNo audio left side from headphones. headphone jack wasdefective.
SONYKV2780R
No picture, replace tv/video switch s-006No picture.
SONYWMF41
During play, tape jamsDuring play, capstan speed and reel speed change causingtape to jam.
SONYFD2A
Wrong p/n for l201Wrong p/n in fd2a manual for l201. i believe it should be1-408-098-00 same as fd20. -hq comments: we will publish correction on this.
SONYKV25VXR
No functionsNo audio, tv or vcr.
SONYSPP100
Base unit would not respond to handsetWhen handset was put in talk mode, talk led would not lightand base would not seize line. when base and handset were put in testmode, high speed id transmission from handset to base was ok. high speedid transmission from base to handset - handset did n
SONYKV1944R
Slight loss of vertical sweep, replaced c523Set displayed slight loss of vertical sweep and foldover atthe top. this capacitor checks good on checker but proved to bedefective.
SONYSLHF900
Noise barsCustomer complained of noise bars at top and bottom of rasterin freeze frame mode. inspection revealed unit worked perfectly on itsown recording, but noise bars present when using alignment tape. viewingrf envelope displayed minor tape path problems ex
SONYXR787R
No audio outputNo output. q212 output high to all mute switches. ic201pin 17 was outputting high.
SONYCCDV110
Bent pin on multiconnectorBent pins.