TV Repair: Common Faults and Solutions.
Search:
Results: 87413
Results: 87413
Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
SONY | STC7000 | Adjustment needed | The maximum deflection on tuner input meter did not correspondto center channel on tuning meter. adjustment of fm discriminator and fmif was unsuccessful. | ||
SONY | SQA2030 | Defective q701 | Noise in back channel outputs. -hq comments: replaced regulator transistor q701, 2sc1124. | ||
SONY | PSX70 | Weak motor | Tone arm would not complete return and play cycle wouldstop widway most times. | ||
SONY | PSX40 | Defective mgh | Turntable speed erratic. maximum output from mgh was 15-20mvp-p. even slight readjustment of the head caused it to scrape theplatter. | ||
SONY | PSX30 | Loose lead on c101 | Frequent slowing down of motor. found one lead of c101loose. | ||
SONY | PSX30 | Defective detection lever | Scraping noise. cause: detection lever had been jammed underprotrusion on bottom of cam gear in shipping and was permanently warped.this was touching the top of the magnet ass'y on the motor shaft. | ||
SONY | PSX20 | Defective ic101 | In play mode turntable operates normally, in stop mode (poweron) turntable rotates backwards. in stop mode, ic102-2 output goesnegative 2.1v and inverting input remains slightly positive (pin 6). theoutput of logic pin 6 of ic101 remains at +1 volt. g | ||
SONY | PSX7 | Defective q203 | Automatic function engages when power is turned on or off, andspeed varies. this only occurs when unit is cold. | ||
SONY | PSX7 | Replacement motor will not mount | During troubleshooting, we found that replacement motor(a-460-801-9a) would not mount properly. dimensions of motor shaft andspindle were different. | ||
SONY | PSX6 | Open cap c205 | After several minutes of operation platter slows down and getsprogressively slower. | ||
SONY | PST25 | Spacers to remove | Platter scrapes on side opposite tonearm. | ||
SONY | PS212 | Leaky q3 | Turntable speed is too fast. | ||
SONY | PS20F | Replacing stylus | The stylus of the moving coil cartridge for the ps-20f isreplaceable. the part number is nd206. | ||
SONY | MDR3L2 | Wires break | The distributor (norcal) has reported to me several brokenwires on these units. the wires break at the plug end. | ||
SONY | M200 | Spring out of location | Switch sw3 did not move to off position when stop buttonengaged. problem was spring (3-561-626-00) was off at stud end, not slideend. | ||
SONY | M101 | Short on mic. | No sound. | ||
SONY | ICFS5W | Solder connection | Sound would come on loud then become low and distorted. | ||
SONY | ICFC805W | Defective ic and r602 | No light in display tube. low b+ to ic. | ||
SONY | ICFC805W | Bridge solder connections on pcb | Clock running 10 seconds fast per minute. | ||
SONY | ICFC511W | Defective clock | The time the alarm is set for moves with the rest of theclock. it will not stay at the time set. |