PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14170
Results: 14170
PHILIPS Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS | ALGUNS MODELOS | Activation of the protection circuit due to a momentary loss of mains power or protection acting at the initial moment of starting | Solution add a 22nf 25v smd capacitor in position 2452 | milton | |
PHILIPS | CHASSIS LO1 | Device turns off suddenly | The horizontal exciter circuit of this device is carried out by a pair of transistors bc337-25 and bc327-25, replace these two even if they are measuring good, note the 25 that corresponds to hfe | Replace the capacitor between collector and emitter of npn 337 -25 | milton |
PHILIPS | 14 GL1010 GR1 AL | When it's cold it doesn't work | C 360, c361, c351 sold out | CALIXSERVICE | |
PHILIPS | 20PT3336 | Don't turn on speaker jumping like a beating heart | Open 1r resistor 3445 | Replace | eletroclaudio aguas belas |
PHILIPS | 20PT9467C | Don't turn on speaker jumping like a beating heart | Open 1r resistor 3445 | Just replace | eletroclaudio aguas belas |
PHILIPS | 20PT9467C | Don't turn on speaker jumping like a beating heart | Open 1r resistor 3445 | Just replace | eletroclaudio aguas belas |
PHILIPS | 21PT534 L9.2 | Without video with audio and then turns off | Transistor com flake kinescopio board | Q7313 q7323 q7333 r3347 | GENIVALDO |
PHILIPS | 29PT656 A10 | Does not come out of standby | Defect in the softer board that is outside the main board | This board is not available on the market | Sergio Luiz |
PHILIPS | 25PT 848 L01 1LAA | Turning off after about 2 minutes | Screen adjustment | Sergio Luiz | |
PHILIPS | PT4131 | Turns on but vertical does not open | 7491 change directly if the voltage on pin 14 of the computer is not 8v | junior | |
PHILIPS | 14PT519A/78 | Channel skipping | C2606 no pino 80 do ic7200 | Osmildo J Silva. Pontes e Lacerda MT | |
PHILIPS | 14 PT | Dark picture with/normal sound | Open resistor r3425 change and that's it, blz | ||
PHILIPS | 21PT4533 | Turns it on and before the image appears it turns off the LED and it won't turn on again, just unplug it. she returns and repeats the same procedure | Defective tube socket | Replace the same one for a new one | eletroclaudio aguas belas |
PHILIPS | 20PT3336 | When turning on the TV you notice that it generates high voltage but then turns off without lighting up the filament | The filament track on the tube plate was broken | I redid the TV track, it worked normally | This email address is being protected from spambots. You need JavaScript enabled to view it. |
PHILIPS | 21PT467/78 | Vertical closed normal output | 1st open resistor 3445 | Replace and run for the hug | SebastiĆ£o Nedina |
PHILIPS | 29PT552A/78R | LED blinks and the TV does not turn on, the power supply and voltages are ok but the TV does not oscillate, it does not generate high voltage. | C2457 470nf dry, at the output of the horizontal coil, I replaced it and it worked. | ||
PHILIPS | 29PT9467 | Preso em stand-by | L105 open, ic201 in reset | renato tranca forte | |
PHILIPS | 21PT9467 | Vertical closed and circulating from the middle to the top to the top and stays stinging like a fluorescent to light | C316 r310 r318 open and the vertical output ic351 tda4865aj and d304 and d305 shorted | Replace them all | eletroclaudio aguas belas |
PHILIPS | 21PT438/538/29PT558/658 LO1.1L.AA | Lines at the top | C2476-2k7 - | + scrape glue underneath | milton |
PHILIPS | 21PT438/538/29PT558/658 LO1.1L.AA | Lines at the top | C2476-2k7 + scrape glue underneath | milton |