PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14168
Results: 14168
PHILIPS Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS | CEM210/78 | Doesn't start | Off | ||
| PHILIPS | 32PFL3805 40PFL3805 PICASSO | Turns on the white LED for about 5 seconds and returns to stand by | Capacitor next to the ci 7kfe shorted, remove/replace. | electronicssupplyparts - Gramado/RS | |
| PHILIPS | FWM575 | Does not turn on, all voltages ok | Panel crystal, remembering that tsound are two, one is under the panel 5406 (8,000k) and 5405 (32,768k) | HAHNRAHN | |
| PHILIPS | 32PFL5606 | Doesn't start | Bad stand by power supply, chopper with internal short, burning ci pwm | This font is difficult to find, I ended up buying the font from ml for the models 40pfl5606d/78 and 40pfl5806d/78, whose std by font is basically the same, especially the choper. | davi.sls |
| PHILIPS | 20PT326A | Blue screen, wouldn't stay on | Defect in the flyback, and in the rgb board | I replaced the capacitor behind the flyback (22μF/250v) and the resistance on the side (3.9Ω) and lowered the brightness level of the flyback to be able to leave it on (it turned off when the brightness was exposed) then the screen was blue without characters no image, only blue, 18kΩ/3w resistor (which takes the color blue) was open, replaced it and it was fine | Dvid Técnico |
| PHILIPS | 32PFL5606D/78 | Does not turn on, no stand by. | 8-legged 3.3v regulator on top of main board | Interreplace 7124 and 7125 at the top of the main one, right at the entrance. | TERABYTE Guilherme Souza |
| PHILIPS | 20PT428A/78 | Image with shaky vertical lines and heating up the vertical output a lot. | C 2476 022k next vertical ci | Replace it without measuring | This email address is being protected from spambots. You need JavaScript enabled to view it. |
| PHILIPS | 220TS | It doesn't turn on cold, it stays in a loop showing the logo and restarting | Capacitors c909, c908, c907 (330uf 35v) swollen, replace | Francis | |
| PHILIPS | 14PT3336 | TV turns on normally but when connecting the antenna signal the image becomes shaky and the +b varies between 80 and 90v | After doing some tests, I was able to verify that the defect was in the 47uf x160v capacitor 2564, which had no capacitance. | After changing it, the TV started working normally again. | ASSISTEC MANARI-PE |
| PHILIPS | 21PT8467/78 | The TV has a kind of flicker, as if someone briefly raised the screen as if tsound was a bad contact on the G2. | Fly-back with faulty screen adjustment potentiometer. | Replace fly-back if this is the case. (tec, edfersom (varjota-ce) | Edfersom |
| PHILIPS | AZ1008/19 | Disk doesn't spin | Shorted spindle motor and r3875 smd resistor 4.7Ω changed to 270Ω | After replacing the components, the disc started spinning again | Eng. Alex Macedo |
| PHILIPS | FWM417/78 | Tsound is no sound | C760 shorted | Replace c760, f804 e f805 | Eletronica Vargas RS |
| PHILIPS | 21PT5433/78R | TV with closed screen at the bottom, does not enter the avenue. | Remove the eprom and erase it... (reset it with the eprom recorder) | J&M | |
| PHILIPS | 32PFL3403 | Noise from speakers when turning on | C2420 and c2423 sold out | Replaced both | Reginaldo WK Eletrônica |
| PHILIPS | 32PFL3018D/78 | ONLY turn on the backlight with the red standby LED on steady, then turn off the backlight and standby remains on. | Corrupted flash memory. Go to the website https://microtecpg.com.br/philips-memoria-flash-e-esquemas-eletricos/ and download the data from the memory corresponding to the television display. In my case it was just re-recording another memory because hers was corrupted, it worked perfectly. | EC | |
| PHILIPS | FWM377 | No sound from bass outputs | Stand by voltage missing from STK pin 13 | Q728 replaced. To clear the doubt, isolate pin 13 of the STK and inject a voltage of 1'5v. Sound should come out normally | samuel leite |
| PHILIPS | NX5 | Fountain pulsing. | Transistor d882 open power supply position q9. | TV CENTER GUAIBA | |
| PHILIPS | 42PFL3604/78 | Dead | Check c88, c89, c100, c101, c103, c104, c105, c112, c125 | Gerson C.C. | |
| PHILIPS | FWM-779 | Turns on and after a few seconds goes back to standby and is stuck in standby | After turning off the power supply to the sound output and leaving only the main board connected, the defect continued, over protection being activated even with voltages all normal | Exchanging the transistor 7506 (bc847b) for a bc557, the device returned to normal | jorge |
| PHILIPS | 32PHG4900 | LEDs burn out | To reduce the voltage on the LEDs | Remove smd resistors r8614 and r8606 | Paial.eletros |