Search: PHILIPS
Results: 14171

PHILIPS Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
PHILIPS29GX1899/78
GR6.LS
No 130volt power supply gun appears and disappears with 30voltTrcar c 2420 470uf e c2411 220ufJCARLOSMART
PHILIPS29PT9467C/78
SK5.1L CA
Vertical closed in half, colored horizontal lines at the top of the screen.Vertical and kinescope plateReplace r924, r919, q904, q904, c904 e d452danielpauly
PHILIPSFWM996/78
No sound from outputsR 910 of 39k, close to the power supply capacitors. the board of this amplifier and the fwm 592/593amp pcbVanoil
PHILIPS20PT3331/78R
Closing the vertical top and bottom of the screen.C2446 (changed)located next to thReplace the same.Jarbas (ELETRO-SERV)
PHILIPS21PT5435
Vertical closed and turns offR 3448 and 3445 open, also check if there is 8 VDC on the 7496 emitter, if not, it will not open verticallyEDGAR THIZ
PHILIPS29PT9467C
TV turns on and off with dark corners activated protection note: with image on screen the TV turns on.Capacitor c438 272 j ou 2k7 secoReplace the memo and the TV is ok.celso cafelandia pr
PHILIPSAZ1134
No sound on CD and radio, exit okFunction key sw1, and q5 and q8 (mute) with leakageCleaning sw1, and changing q5 and q8 or eliminating the 2 transistorseletronicadoalemãThis email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS21PT9467
Audio with superimposed whistleAsp plate crystal (the one that stands upright)Solve it / if it doesn't solve it, replace itwarley cesar
PHILIPSPT222A
Blowing fuseTransistor 7518 short, changed transistor and c 2518Resolvedsergio
PHILIPS21PT836\78
L9.01A
No Audio\no sound - note: all voltages in the normal amplifier tda 7057aq.Pencil tip inside the female jack.This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS21PT836\78
L9.01A
Note: all supply voltages in the normal amplifier (tda 7057aq).Cause: pencil tip (graphite) inside the earphone's female jack (on the front panel) phew!!!!!This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS21PT5433
L03.1L
Flattening of the image only at the bottom of the screen100n capacitor 2488 connected to pin 26 of the ci 7200Make the replacement and see for yourself! beauty?!elsonkatin
PHILIPS21PT5433
Contrast does not workAfter testing everything and finding nothingI disconnected pin 49 of the ci 7200 (processor). problem solvedThis email address is being protected from spambots. You need JavaScript enabled to view it. (bruno)
PHILIPS40PFL5605D
Doesn't workPower supply turns on but 3v3 is missing from the microShorted d907 d911 diodesAlvaro (prolar)
PHILIPS21PT5433
It turned on then turned off in approximately 2 minutesC2463 and c2465In my case, that's all it was. Thanks guys, let's send you a tip lolRafael Dores
PHILIPS29GX1899
Turns off as soon as it comes out of stand-byCheck the voltage of the ic 7800 and resolder it and check the diode 6571 in4141Replace the diode 6571 in4141DAVI PEIXE-BOI
PHILIPS42PFL3604
Doesn't turn on, everything is offC806 4u7/450v exhausted in the primary causes the burning of other components in the primary of this 3v3 power supply.C806 4u7/450v depleted, r801 2r7 and r825 2r7Ω open and u801 = fsq510 shortedBRUSKE
PHILIPS29PT554
Apparently normal power supply, but it doesn't turn on, triggers protectionC2551 47 x 160v seco.This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS20PT3331
Works for a few hours and appears retrace lines and turns offDefective scrim potentiometerFlyback replacementeletronica reis
PHILIPS20PT3331
Turns off after some timeCapacitor 2303 on the tube plateReplace without measuringeletronica reis