PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14174
Results: 14174
PHILIPS Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS | 21PT 8467/78 S L O 3 1 L | TV doesn't work | When this TV turned on, it made a hissing sound like a high leak and a line appeared in the vertical direction. Solution changed to r- 3445 of 1Ω, it was open. OK | jaironuness | |
PHILIPS | 33PT578 | Turning off by itself and heating the horizontal output | Electrolytic capacitor c-2455 - 47mf/25v with changed capacity | Capacitor replaced | Eletrônica Carlos - Salvador |
PHILIPS | 20PT120A L7L | Normal image after a few minutes the image becomes drizzled and disappears. | Ic 1002 | Short the 100k r which is on pin 5 of ic 1002 | Igor Almeida |
PHILIPS | 14 PT 110 L7L | TV turns on in service mode | Smd capacitor below the memory | Edson Peixoto | |
PHILIPS | 29PT6456 L04-UAA | Works for +or- 1 min, taps the image and turns it off | Poor filtration at +b (160v) | Replace the cap 2552 (with less than 93μF) | MAIRES |
PHILIPS | 24PW6006/01 L01.1E | Power supply without output voltages | Slightly low voltage on pin 1 of the ic7520 (power supply) | C2526(470n smd)com fuga | MeA |
PHILIPS | 20PT424 | Does not turn on, the standby LED flashes | Power supply cap 100uf/25v change it you can measure it is good | I replaced it and the TV went blank | ELETRONICA ARNI - L. LEAL |
PHILIPS | 20GL1049 | Just getting uhf channels. | Altered resistor3101(22k) | Luciano Fontes | |
PHILIPS | 29 PT 5645/78 | TV didn't work primary power supply seemed to be fine but after the tr there was no b - primary power supply doesn't work | After a lot of head-scratching, a 82k secondary 3575 resistor was opened | ELETRÔNICA NYLSOM - This email address is being protected from spambots. You need JavaScript enabled to view it. | |
PHILIPS | 20PT3336/78 | Does not enter the av and there is no sound | Memory exchange | Obs. I replaced it 3 times and recorded it f'' | Neguinho(itapevi) |
PHILIPS | 21GX1668/78R | Tv doesn't work | Check r3511(24k) altered value | You can replace it with a 22k one | almicrrc |
PHILIPS | 14GX1610 | Stop without +b | Replace do flay back at 2079/b4 | bt | |
PHILIPS | 20PT424A/78R L9.2A | Stand by flashing quickly | Replace capacitor 2530 and 2540 | somprimos eletronica | |
PHILIPS | 14GL1310 | Buzzing in the speaker without sound | Capacitor 140 (ceramica 22k) | ||
PHILIPS | 29PT558A | Does not oscillate | 3491 - 10k | silva2 | |
PHILIPS | 29PT652 A8 | When turning on there is a smell, it doesn't work, it stops | Shorted capacitor 2634 | Replace | fernandoferreira |
PHILIPS | 21PT5143 | TV oscillating, but completely turned off, found that there was no screen. removing the socket from the tube, the voltage arrived, resulting in a short between the pins: 8 (screem) 5 and 6. | I removed the short using mains voltage (220v) with a resistor in series. | The short was eliminated and the tube was ok. | Léo, Natal-RN |
PHILIPS | 29PT4631 | Does not tune channels and disarms in 15 seconds. | 5v voltage originating from the tsh, with 2.8v | Replace trans. 7482 : bd135 | This email address is being protected from spambots. You need JavaScript enabled to view it. |
PHILIPS | 20GL1346 | Green and pink and blurred image | Incorrect transcoding | Replace tda4662., first check the ceramic capacitors connected to the circuit | ELETRÔNICA ESTUDIER |
PHILIPS | 25ST2451/12B GR2.2AA | Dead power supply. no voltages in the secondary. You can only hear the primary wanting to start. | Replace c2545(1nf5-2kv) next to the high transistor (7545) | TELEGAIA |