PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14173
Results: 14173
PHILIPS Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS | CP110 | Continuous page header display in subtitle | Change text ic to type mab8461p/w196 part no4822 209 62479 | ||
PHILIPS | CP110 | Channel display goes to " e " | Micro 7840 | ||
PHILIPS | CP110 | Chan display reverts to"e" | Micro 7840 faulty | ||
PHILIPS | CP110 | But11af gets stuck in stand-by mode; but11af gets hot. | Check the value of resistor r3659 (100Ω). the fault occurs when the resistor is open or when the value is increased. | ||
PHILIPS | CP110 | Brightness varying. | Check/replace d6401 (1n4148: 4822 130 33939) on crt base pcb. | ||
PHILIPS | CP110 | Bottom of raster missing | R3572 o/c 1r5 | ||
PHILIPS | CP110 | Blank screen - gives blue screen with fb lines when a1 advanced | Tr7405 bf423 on crt base s/c | ||
PHILIPS | CP110 | Blank raster with "e" in display | Micro s/c to chassis | ||
PHILIPS | CP110 | At times no contrast. | Replace t7415 (bc556; 4822 130 40989). | ||
PHILIPS | CP110 | 3 page layout with faults - pic cover june 93 | For more faults see also cp90 most of chassis is the same. | ||
PHILIPS | CP110 | 140v rail low ( 60-70v ) | C2661 2200uf oc use philips part only | ||
PHILIPS | CP110 | 140 volt rail collapses after 5 minutes. | Replace standby switch transistor, t7739 - bc548 (4822 130 40938). | ||
PHILIPS | CP110 | 1 mm curl in vertical lines | Capacitance of capacitor c2633 100 uf (4822 124 41584) has decreased (dried). capacitor c2670 22 uf (4822 124 22257) hot. | ||
PHILIPS | CP110 | "memory loss" of one or two arbitrary programmes | Disconnect pin 34 of ic7840 from the +6 volt. add diode 1n4148 (4822 130 30621) between +6 volt and pin 34 of ic7840 (with cathode to point 34 of ic7840). add serie circuit of resistor 10 kΩ and capacitor 100 uf/10volt (4822 124 40184) between +6 vo | ||
PHILIPS | CP110 | "f1" displayed & field collapse | Dry joint 12v reg ic7675 | ||
PHILIPS | COMBI | Remote control not responding | Check not set to vcr2 - press stop & 1 together or removing batts will restore vcr1 setting | ||
PHILIPS | CM11342 | Dead - squealing noise from psu. | No 128v rail , r3412 ( 33k ) o/c. | ||
PHILIPS | CM11342 | Cutting out int. | Poor connection on scan coil plug | ||
PHILIPS | CF1 | Tripping | C2322 47µ ht cap was o/c | ||
PHILIPS | CF1 | Rolling - no field sync | C2377 10µ o/c, also replace c2368 & c2369 4µ7 63v |