PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14168
Results: 14168
PHILIPS Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS | 40PFL5605 40PFL6605 | Inoperative. doesn't connect at all. no stand by led | Shorted diode d911 | Really replace and go for the hug | Deusomar |
PHILIPS | 14GX1515 | Doesn't start | Power supply plate capacitor 4.7x25v 47x25v | Capacitor | ELETRONICA MAURI JUNIOR |
PHILIPS | FWM371 | Standby LED comes on but does not turn on | R39 of 4r7 roasted | Just replace | paial.eletros |
PHILIPS | 20PT122A/78 L7L | Without video, without osd, with sound | Sande castle no pino 38 do tda 8362 com 4v. | Replace d6461, in4148 with leak | jasvan souza |
PHILIPS | 14PT3336 | Doesn't work, doesn't light up or stand-by | C.i power supply oscillator str-w6765 | Eletronica Lelo | |
PHILIPS | 21PT5433/78R | It called with normal audio but a hundred images. I wasted a lot of time with several attempts. and nothing. | R 3442 of 100k open | raul de saja | |
PHILIPS | 29PT8457 .... | TV works normally but with a high pitched noise | Non-horizontal coil l 5401 | Replace | E matos |
PHILIPS | 20PT326 | LED lights up, comes on high, then turns off | R3630 (47k) aberto | cabessaonatal | |
PHILIPS | 21PT5435 | Nothing turns on, not even the stand bay LED. | Photo coupler | Changing the photo coupler | Eletronica Valenca |
PHILIPS | 42PFL3604 | LED blinking weakly did not turn on | I replaced c806, they say it has to be original (4.7x450v) for a 10x450v one, no problems | ||
PHILIPS | 40PFL5615D/78 | Does not turn on, does not light up standby LED, no power supply on the secondary circuit of the power supply board | Check diodes d907 and d911, both sb260, which are in parallel. | One or both may be shorted. replace both, even if one of them measures good. replace with the same value sb260. mbr360 also goes in place. | Diego Korvo Ponta Grossa |
PHILIPS | 32PFL3403 | Image disappears, backlight on, display voltage low, less than 10v. correct voltage is 12v. | Replace 5v6 zener diode position 6r02, on the 7r10 regulator transistor side. back side of the main board. | joaomvjr | |
PHILIPS | 20PT3331/78 | Does not turn on or the LED lights up | Killing the 3.3v | Check pins 54,56 and 61 measuring on the diode scale black tip on ground and red on related pins reports short replace microna tda9370ps/n2/ai | toninho da eletronica |
PHILIPS | 26PFL3404 TPS2.1E LA | It doesn't turn on anything, it doesn't even have 5v on standby | Ic 901 (tny274pn) | Baguatech | |
PHILIPS | 29PT554A | Dark horizontal lines across the screen. | 3411 open resistor | Nedson | |
PHILIPS | 21GX1665 | Jagged and shaking image | The 2 47/160v capacitors | And just replace and plz | EDSON SAO LOURENCO MG |
PHILIPS | 32PFL3404 | Does not turn on, stand by on, no 24v power supply | Doubler circuit with low voltage in c3 and c4 | 12v relay, k1 defective | VipCenter |
PHILIPS | 21PT5433 | This device arrived at the workshop stopped. | I found that s.horz. It was short replaced and it burned out again because the trans. It was fake, I put an original one, it worked but the tsh was leaking, I replaced the tsh. great, but the remote didn't work, I noticed a defect in the computer | JARBAS ALVES | |
PHILIPS | 29PT5642/78 | Vertical closed, incomplete missing 2 fingers on each side | Measure the vertical coil; good 8 homs, defective 16 homs | Dismantle the deflector coil on the vertical part, tsound will be a loose wire, solder it and that's it ok...solved... | ADRIANO..RIO VERDE MS |
PHILIPS | 42PFL3604 | Turning off lamps continues with sound | Bad contact in one of the lamps (note any touch on the TV) | Open the panel and re-solder the lamp sockets | carlusat |