Search: PHILIPS
Results: 14168

PHILIPS Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
PHILIPS FR752 RECEIVER
Fm inoperativeAfter changing the resonator (x101), c.i 103 (lm7001) and with no result, I removed the l103, broke the internal capacitor, placed another 82pf under the board and the problem was solved. good luck .<small>This email address is being protected from spambots. You need JavaScript enabled to view it.</small>
PHILIPS42PFL3604/78R
Turns on, shows the image, the LED changes to white then, you can increase the sound or not right after, turns off without returning to standbyReplace c3 on the signal board next to regulator u5, it shows a leak with a value of less than 1.0Ω when the voltage varies from 3.3 v. and everyone goes in for a hug!Checking that the voltage of regulator u5 drops by half, I found that c3 next to regulator u5 is leakingROGERIO FRANCO IPATINGA MG
PHILIPSFWM589
Turns on normally, after a few seconds it turns off/goes into protectionMany cold solders on the voltage regulator board (above the transformer), due to the age of the device.Fernando SS
PHILIPSSA-AK970
Sound turns on stand by when it goes back to stand byPower supply cooler defect stoppedReplace the same one for a new oneadriano SB
PHILIPS40PFL3606D/78
No image but with sound, dark image with bandsT-con panel, check 750k resistor next to ic:7j00l
PHILIPS14PT112A
It doesn't start, LED flashes straight on.C2447 [470 pf/ 2kv] shorted.Altevir Lima [Valparaíso Eletrônica/ Ananindeua - PA
PHILIPS21PT9467C
Cushion effectAfter replacing q303 and c327 the device is still defectiveL-301ELETROBRITO
PHILIPS20PT326
Does not turn on, nor does the LED light upPower supply resistor 3510 33k (powers the vcc of the power supply oscillator)cabessaonatal
PHILIPS20GL1045
GR1-VA
"opaque" image, meaning no contrast.Causa: ic 7200 - tda8361 ou tda 8360.Replace it and go for the hug!!! God blesses everyone.This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS20PT524A
Blinking LED takes a while to turn onPrimary and secondary capacitorsReplaceELETRONICA MAURI JUNIOR
RECEPTOR DE PARABóLICA PHILIPSDSX 1000
Doesn't work.+b normalCheck the diode (d-19 1n 4148 shorted)Ademar Videira SC
PHILIPS29PT 9467
Barrel or cushion-shaped sides.Replace ( q-440 zd440)Ademar Videira SC
PHILIPS20PT 3331
I'm soundRemove the diode (d-6809 and 6908)Ademar Videira SC
PHILIPS14PT 519
Turns on works, but sometimes turns on and off.Change photo coupler and transistor q-7540.Ademar Videira SC
PHILIPS29M4505
Closed vertical.Replace (r-3488 4k7 )Ademar Videira SC
PHILIPS29PT 4641
Oxila turns on and off with 3 vertical stripes.Replace capacitor ( c-2465 10 uf x 250v) e (d-6457 1n 4148)Ademar Videira SC
PHILIPS20GL 1047
No contrast.Change resistor r 3555 (27k) connected to pin 8 of the fly back. abl.Ademar Videira SC
PHILIPS9467/S
Tsound is a hiss or noise in the sound in (vhf) in normal audio, as the volume increases the noise also increasesThe problem is located on the (fm) board wsound the ic 801 is located.In my case, I just resoldered the board and the problem was solved.Ademar Videira SC
PHILIPS32PFL3605D
Turns on and off LED flashes two and four timesShorted speakersReplacepaulo-maceio/al
PHILIPS40PFL5605
It doesn't turn on or stay on standby.Falta de z,zv on plaça da power supply.Diode d911 shorted. (it is in parallel with d907)Persio(TVCompany)