PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14169
Results: 14169
PHILIPS Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS | 29PT4635 | It turned on and then turned off, I changed it c2455 47u turned it on and held it but the screen is closed and serrated. | Check the deflector as it makes a strange noise. | Changing it is beautiful (dhf-2912pl) 1.8 to 2Ω horizontally and 13.6Ω vertically. | Eronaldo(arteron) |
PHILIPS | 29PT554/78R | The TV sometimes turns on and sometimes doesn't, when it doesn't turn on the LED blinks continuously and the b keeps pulsing. | The power supply does not activate, the slow starter does not work. | C2540=100μF 25v was replaced, it was average in the test at 80μF, and c2530 of 1μFx100v was also replaced, I replaced the c2530 with a 2.2 x 100v one, I replaced the value of the original and it worked beautifully. | Armando da Eletronica EvoluSom. |
PHILIPS | 14PT3336 | Vertical closed | Varicap | Replace varicap | ELETRONICA MAURI JUNIOR |
PHILIPS | 29PT558 L01.1L | Hits the relay and doesn't turn on. | R3543 (82k) | Replace | joaomvjr |
PHILIPS | 29PT554A | Retrace and disconnect lines (without 180v) | R3340 pci tube 0bs: measure d6335 sometimes with leakage and the r3340 burns again! | Guto | |
PHILIPS | 14GL1015 | Low brightness, opaque image | R3555 (27k) open | Replace and run for the hug | Eletrônica Staub |
PHILIPS | 21PT5433 | Doesn't start | Check resistor 3527 primary power supply | amsmariano | |
PHILIPS | 14PT3131/78R | Retrace lines at the top of the image | 68nf/250v dry capacitor position 2460 | As I didn't have a 250 volt one in stock, I replaced it with a 50 volt one since the vertical one works with low voltage. | Helio Eletrosonic |
PHILIPS | 40PFL5605D/78 | Total shutdown. | D707 and d711. I used the uf4004 because the 1n4004 is not a quick cut and sound in Belém the material is complicated. | I appreciate the tips from friends. ferraz, bruske and electronicaaeb. | @gepe |
PHILIPS | 14PT4331 | When you turn on the TV, the image is a little blurry and turns off. It looks like a tube defect. | R 3444 amended | Esper | |
PHILIPS | 32PFL3605D | Does not turn on or light up normally | PCI board defect | I just replaced it and it was done! | ELETRONICA AUTO TREVO |
PHILIPS | 21PT5433 | Noise in the sound on stereo channels | Configurar lista de option byte ▬ob1 = 0 (tuner alps), 128 (tuner philips) ▬ ob2 = 192 ▬ ob3 = 64 ▬ ob4 = 224 ▬ ob5 = 72 ▬ ob 6 = 0 ▬ ob7 = 80 | eletronica ndn | |
PHILIPS | 29PT5645 | Doesn't work av | Configure the following items in service mode 29pt5645/78 - op1 = 0 (alps tuner), 128 (philips tuner) - op2 = 160 - op3 = 128 - op4 = 164 - op5 = 250 - op6 = 42 - op7 = 0 | eletronicandn | |
PHILIPS | 29PT5645 | Configure the following items in service mode 29pt5645/78 - op1 = 0 (alps tuner), 128 (philips tuner) - op2 = 160 - op3 = 128 - op4 = 164 - op5 = 250 - op6 = 42 - op7 = 0 | eletronicandn | ||
PHILIPS | 21PT326A/78 | Blinking led | Replacement | Flyback | fco |
PHILIPS | 40PFL5615D/78 | The television turned off by itself and wouldn't turn on again. | Diode d911 shorted. replaced with 1n4004 for testing. | I will replace it with the original later to avoid future problems. | Ferraz |
PHILIPS | 32PFL3404 | Does not turn on sometimes tsound is only sound | Capacitor azul cf01 | JARBAS A BRITO | |
PHILIPS | 42PFL3604 | Tsound is no 24 volt voltage at the power supply | Na power supply r849 10Ω smd e diodo d5 comum smd | Na fonte r849 10Ω smd e diodo d5 comum smd | edgardsdo |
PHILIPS | 14GL1316 GR1-VA | Does not turn on with noise (the power supply oscillates but tsound are no secondary voltages). | T 7348=c547, r 3348=11k e zd 6346=zener de 91v. | FERNANDO S | |
PHILIPS | 29GX1899 | TV turns on, has sound, has filament, changes channels, everything is normal, but with an image with a blue tone with faint retraces, without characters | Replace eprom | play back |