Panasonic TV Repair: Common Faults and Solutions.
Search: Panasonic
Results: 2880
Results: 2880
Panasonic Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PANASONIC | TC14A10 | Vretical 5cm aberto. | R425 open | Replacement | This email address is being protected from spambots. You need JavaScript enabled to view it.(floripaSC) |
PANASONIC | TC-14A9 MX5 | Does not turn on generates and cuts normal power supply | Shorted vertical output | Replace | eletroclaudio aguas belas |
PANASONIC | 29KL05 | Closed horizontal | Capacitor acopramento c563 | Replace c563 | JOAO DANATS |
PANASONIC | TC-20C4 | Crackling sound | Dry c223 | Replace component | CSOM |
PANASONIC | SC-AK300 | It doesn't turn on, the stbay light stays on 8817 friend of inacio 05/18/10 | Relay q connect open transformer | 6v relay replacement | marcos melo cascavel ceara |
PANASONIC | NNST568WRUK | The plate and propeller motor that cools is directly connected | Defective relay does not deactivate, stays on directly | Help yourself leave your tip | ELETRONICA ARNI-LEOBERTO LEAL /SC |
PANASONIC | TC-20A10 | The screen appears blurred and in the shape of a rainbow | Tube socket | Replace for new | eletroclaudio aguas belas |
PANASONIC | TC-20A10 | On becomes off power supply inoperative | Diodo zener d851 de 24v | Replace for another | eletroclaudio aguas belas |
PANASONIC | TC29KM03 | Line from top to bottom horizontal | C 568 of 394j x250vdcc with capacitance loss | Replace for one of the same good luck | EVALDO GOMES URUÇUI-PI |
PANASONIC | TC 29LK04 | Burning horizontal outlet | Q551/c5902 s.h. - r520 e 521/0,27Ω 1w - d556/rh 3g - c563/0,39p 250v - q753/d2693a - r768/10Ω 2w | Replace them all | eletroclaudio aguas belas |
PANASONIC | TV-20A7 | Electrical discharge: short, change q801, q802, q805, d817fd312s, turns on and still did not oscillate. | Replace ic 601 an-5192ka | Replaced it worked normally. | Eronaldo |
PANASONIC | TC 29LK05 GP3 | Horizontal closed, it was capacitor c563 when I put it in it didn't work but the resistor r768 de10r smoked | I short the transistor q753 and the diode d556 and burn 2 resistors r20 and r21 of 2r7 | Swapping them worked great. | eletroclaudio aguas belas |
PANASONIC | TC14A8 | It has a power supply, but it doesn't oscillate and the 9 volt output from the power supply is low. I removed the vertical output and it worked | After changing the vertical outlet it worked normally | José gusmao | |
PANASONIC | TC20A12 | Turns off, and the LED keeps flashing | Ground pin 36 of the microprocessor | edson proesi | |
PANASONIC | TC20A10 MX5Y | Tsound is no audio | Replace c203 10uf/16v | Replace c203 10μF/16v | ELETRONICA CENTRAL ITAPOLIS SP |
PANASONIC | TC-29A8 NA6L | TV when turned on goes into protection and only works if unplugged | Defective flyback. | Helio Eletrosonic | |
PANASONIC | TC-29KL05 | It doesn't turn on, I deactivated the protection on ic 451 pin 05, the screen was a little off, I turned on the TV and it oscillated normally. So I turned on the IC 401 protection and adjusted the screen. it worked normally. | Doesn't start | I deactivated the protection and adjusted the screen, then activated the ic 451 protection. | VALDO RECIFE |
PANASONIC | TC14A8 TC20A8 TC14A9 TC20A9 MX5 | Three to four retrace lines at the top of the screen | This symptom occurs when the memory (ic1102 - code s- 24c02adp) is changed or when the memory data is changed. | Enter service mode chq3 and lower the vertical center vc to enter service mode check page 06 of the tc-14/20a9 service manual. | Ronaldo |
PANASONIC | TC14A12 | Only turning off after a few minutes | I replaced c519 from 33mc 160v to 45mc 220 and tsound was no more problem | Romeu | |
PANASONIC | TC-20A7 MX3-R | Power supply drops to 50 or 60v, closing horizontal or image shaking | D811 is r818 | Sometimes cold welding on the power supply causes this defect as well. | Bruno. |