Philco TV Repair: Common Faults and Solutions.
Search: Philco
Results: 4740
Results: 4740
Philco Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILCO BRITANIA | PHT 660 | Doesn't start | +5v power supply with load of approximately 2.6v | Cold welding on l1 | |
| PHILCO | TPW3280 | Works normally but when changing functions the av turns off | C 708 5n6 with low capacitance 3n5 | Lima | |
| PHILCO | TPF 2940 BL29 | Does not tune the loud channels | Varicap in os 33volt | Replace d 202 zener 33v | luiztvsom |
| PHILCO | TP2054 | Everything works but dull | Vertical protection | D 602 with small leak | joansa eletronica |
| PHILCO | PCM-2044 | Works normally. After a few minutes the screen starts blinking at intervals, especially when the screen contrast is very wide. | R-713 of 100k amended. | guaracy borges | |
| PHILCO | PC1444 EMOTION CPH 05 | All normal voltages do not work (95v c911- c915 with 15v or normal 5v, no voltage on the collector of q702) | C704 shorted | New tip... | Elias2305 |
| PHILCO | PCM2044-2046 | Sobbing and doesn't start | Voltage of 20 is 16v, the others are normal, resolder resistor r708, take 2 wires, solder from the collector q702 to the tt702 pin, follow the trail, the same thing on the other pin from t702 to r708 | Place the wires, follow the tracks from the resistor to the t702 pin and from the q702 collector to the t702 pin | toninho da eletronica |
| PHILCO | PCM2046 | Doesn't start | There is no 160v on pin 3 of the str 50103, this voltage only comes to the t901 pin | Replace t901 or try to restore it | toninho da eletronica |
| PHILCO | PCM2046 | Blue screen normal characters | L001 close to the 9v regulator that couples the 9v to the varicap, cracked solder. | Resoldag | toninho da eletronica |
| PHILCO | TPF3221 | No image on the channels, if you twist the pci, it works | Resolder pip ci and surroundings | WARLEY CESAR | |
| PHILCO | PC2035 | Nor 95 volts | Shorted flyback | Replace | juci |
| PHILCO DVD | PHT660N | No sound from audio outputs, normal out line | Pin 9 of the cis sta540a without the 9v standby, unsoldered them and the voltage appeared, solder them one by one to see which one kills the voltage. Once that was done, there was a short circuit, he replaced it and both ciss started working again. | CALIXSERVICE | |
| PHILCO | PCM1444 | LED blinking non-stop and without horizontal and vertical synchronization | Tda3653b electrolytic capacitor 2.2 mf c408 replace without measuring | Tda3653b e c408 2,2 | macceletronica |
| PHILCO | TPF 2940 BL29 | Off stand by does not light up or turn on | Check primary power supply | Direct replace r911 -2m2 r 909 -680k and d 915 replaced | luiztvsom |
| PHILCO | PCM 2046 | Green league takes time to open | C 722 sold out | Replace the c722 470 16v | gesnier bispo |
| PHILCO | PCS2952 | TV turning on and off with white lines and glare in the center. | R 705 e c 718 | Replace the resistor and capacitor | ELETRÔNICA VINISOM E TV |
| PHILCO | PCS2700 | Missing preta na canvas | I will go 18 | Replacement | This email address is being protected from spambots. You need JavaScript enabled to view it. |
| PHILCO | PCS 2700 | LED blinking weakly and no +b | Capacitor 220y/200v aberto | ÁdrianChapadãodoCéu | |
| PHILCO | PCS2956 | Excessive width | Wide capacitors check all | A capacitor 8n2 /1600 c 706 com internal flake. | fematch |
| PHILCO | TP-2920 | Relay knocking when I press the power key | Flyback | Replace it | HIPERELETRONICA SERVICE(MARCELO) |