Philco TV Repair: Common Faults and Solutions.
Search: Philco
Results: 4741
Results: 4741
Philco Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILCO | TP2052N | TV with sound and normal characters but without image. | Replace 47k resistor 715 on the abl line. | Pedro Ironei [Assitel Eletronica] | |
| PHILCO | PH29C | With audio, characters but without video/image when increasing the screen but with lines | Eeprom | Replace the naughty and go for the hug!!!!!!!!!!!!!!!! | paulinho |
| PHILCO | PH 21SS | Vertical closed half down (appearing folded) | -15 volt line | Replace c 562 and c563 and check diode vd 567 1n4148 | eletronicavalenca |
| PHILCO | TV PH 29 | Turns on and off after +- 5 seconds and tracks on the left side | C 450 680pf 2kv | krul | |
| PHILCO | PH21A | Sometimes with a good image, sometimes with an intermittent reddish or yellowish image. | Def no rgb circuit | Replace the 3 c2482 transistors even if they give good results in the test. | samuel leite |
| PHILCO | PH21B | TV works - upright keeps shaking until it closes | Xs 401 -connector- cold solder - | Connect the cables directly to the board | EMERSON RIBEIRO |
| PHILCO | TPF2130 | Remote control does not work | C1102 and 1103, replace without measuring | claudioaudioevideo | |
| PHILCO | TP1452 | Triggering protection | Zd 941 30v. | Barter it | E MATOS |
| PHILCO | PC 1445 | Vertical closed | 15k open 602 resistor | Jairo Matos da Costa | |
| PHILCO | PC 1443 CPH 05 | TV does not turn on blinking stand-by LED | Resistor r. 15k 808 on the open kinescope plate | Remove what. 901 outside and turning on the TV showed an excess brightness of the blue cannon | Floriano |
| PHILCO | TP-1452 0000 | Volume increases too high and decreases without control | Memoria eprom | Replace for one of the same model | marcos melo cascavel ceara |
| PHILCO | TV PH21B | AV inputs don't work | Replace ci. n801 , cd4052 , | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
| TV PHILCO | PCR1449 | Burning power supply fet | Replace capacitor do primario (c905) 200mf x 385v | I replaced it and tsound was no more problem with the fet burning. | RBEletronica |
| PHILCO | PCM 2046 | Closed vertical. opens intermittently. | C613 (2n2 ceramic), from pin 2 to pin3 of vertical output IC 601 (TDA 3653), with changed value | wperry | |
| PHILCO | TP 1452 N | TV with LED on and won't turn on | Resolved: flyback replacement | mallasyia | |
| PHILCO | TP-2052N XXXX | TV does not turn on, sometimes it turns on the power supply voltage varying from 40 to 70v with noise in the speaker knock-knock touching the tip of the soldering iron to the capacitor 913 turns on but when turned off it does not turn on again | When the TV is cold, it turns on. Solved: T901 has the ferrite open, remove it and put it together and stick some tape ok | Just add the ferrite of the t901 transformer to be open.una -o | toninho da eletronica |
| PHILCO | PCM 1445 | TV works normally, when the image varies, a black stripe appears vertically | C= 721 as lack of capacitance | I touched and resolved | ELETRONICA MEDEIROS |
| PHILCO | PCM1446 | Inoperative TV turns on the key, it only comes with a whistle. | Capacitor 911 de 220mf/160v seco. | Replace and go for the hug. | eletrônicavinisom e tv |
| PHILCO | TPF-3221 | Closed the horizontal, it worked normally, the incision burns the exit h | C708 5n6/1600(about//i) | WARLEY CESAR | |
| PHILCO | PH21US AI | Turns on and off, vertical seems closed, the ci n401 - stv 9378 is good. | Transistor v502 open | Troque o v502 - c2383 | Paulo Sertel Itararé SP |