Search:
Results: 87430

Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
SONYKV1925R
Volume increases and loss of mode control, replaced cp-102After warm up, volume would increase to maximum: display wouldindicate maximum volume and remain on-screen. unable to change volume,channel, or anything else. if set unplugged, and then again powered up,default to (aux) antenna mode (this model does no
SONYXR7150
Noisy mechanical sectionIf the mechanical section is noisy, check that, looking fromthe top, the rvs gear assembly (page 43, ref. no. 215) is behind the leafspring (part of mechanical chassis assembly no. 224). if it gets in frontof the leaf spring, all the functions will work
SONYWMAF58
Poor fm receptionUnit will only receive the strongest fm stations. weakstations are muted, and border line stations will constantly mute in andout of mute.
SONYKV2680R
Technical data does not assist with troubleshooting, ic-104The following words were spelled as indicated. all otherdisplays were spelled correctly. sleep - slgep, muting - mutwng, aux -auxe, video - vidfo.
SONYCCDV9
Microphone part numberTheir is no part number for the microphone on page 178 of the service manual. -hq comments: part number for the microphone is 1-542-089-11.
SONYCCDF70
Ejects half-way then reloadsWould eject half-way stop and reload.
SONYCCDF35
No picture after a whilePicture began to get dim until no picture at all.
SONYSLVP30HF
Distorted picture and soundSevere distortion both sound and picture. audio sounded likespeed was too fast and picture had horizontal line resembling a picturewhich was severely out of horizontal sync. ic-651, pin 13 had videopresent but no video on pin 12. pin 10, ic-651 was 0v
SONYCCDF35
Distorted video, no audio, no recordDistorted video, no audio, no record.
SONYCCDF50
Lcd display inoperativeCould not set date/time or reset counter.
SONYSLV70HF
Picture rolls and no color in playbackPicture rolls and no color in playback mode. traced problemto no sync from ic-701. found c-701 chip cap bad.
SONYMDP200
Ld picture distorted and cd does not play1. distorted ld picture. 2. cd does not play.
SONYD25
Part number incorrect q-409Part number of q-409 is incorrect. the correct part number is8-729-921-85. -hq comments: a service bulletin has been written and will be issuedshortly.
SONYXR7050
Incorrect partThe part kcp sends is a chip component. the part needed isthe one shown on page 11, column 2, third down - 2sc3900. is the partnumber listed in the service manual correct or has the parts departmentsomehow mispackaged this part? -hq comments: the tran
SONYCPD1390
Shutdown after warmupOhm meter check between hvr and gnd measures 100k - 120kΩ:too high. both part numbers above sub to 1-230-666-21, which normallymeasure 100kΩ or slightly less: ok.
SONYCPD1303
Shutdown after warmupOhm meter check between hvr and gnd measures 100k - 120kΩ:too high. both part numbers above sub to 1-230-666-21, which normallymeasure 100kΩ or slightly less: ok.
SONYSL340
Unit inoperativeUnit inoperative. we found regulator, ic-001, is power supplywith all leads internally open. this is the third time i have been shownan ic like this. i am sending sample for your investigation.
SONYCCDF40
No servo lockNo servo lock. a strip or snow keeps running up the screen.
SONYSLHF1000
No capstan rotationLost 5v at pin 14, ic-505 found c-817 shorted. found coldsolder joint on 5v path at the eyelet left side r-600.
SONYCFSD20
Power transformerSupplied transformer - same part number, does not fit drilledholes. drilling an additional hole for primary side allows new trans-former to work. -hq comments: i will check with tokyo and kansas city parts to see ifthe part has been changed.