Search:
Results: 87426

Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
SONYXR66
D856 wrong in parts listD856 is listed as a switch with a switch p/n in parts list.i need p/n for diode (led) in center of push button.
SONYCCDV5
Ref. no. 2 and 18 are reversed, page 191 in s/mPage 191: change ballons ref. no. 18 and 2 in servicemanual. -hq comments: a service bulletin will be issued.
SONYSL5600
Noise in middle of picture during playbackNoise in middle of picture during playback.
SONYAPM990
Speakers rattleBoth speakers rattle.
SONYKV2680R
Snowy picture, replace q-1132 and q-1133Snowy picture on higher channels.
SONYKV25VXR
No vertical sweepNo vertical sweep.
SONYKXM270
No video, replaced ic401No video.
SONYKV2091R
Bad picture, leaky c1505Broken lines in picture.
SONYKV2093R
Looses memory, replace memory ic102Looses memory after a period of time.
SONYCCDV110
Zoom not workingNo power zoom, no auto focus.
SONYCCDV3
No color in pictureNo color in picture.
SONYSLHF1000
Picture jumps in special functionsPicture jumps in still mode and will not adjust.
SONYIT600
Will not operate in ff modeUnit would perform in all functions except in ff mode.suspected that power demands was not being met. inspection of ac adaptorreveals slight ripple in dc supply.
SONYSL2000
Unit spills tape then shuts downUnit would spill tape and then shut down. capstan would runvery fast. inspection revealed no fg pulse at tp-405. i found c429 tobe the cause of the problem. it was not open or shorted. problem valuechange.
SONYCCDV8AFU
No camera luminancePs602 increased in resistance (1.4 kΩ).
SONYCCDV110
Viewfinder rolls in camera mode onlyCamera mode picture in evf rolled. but picture, in evf, invtr mode did not roll. camera mode monitor (rf) output video did notroll.
SONYD5A
Use with ebp-300 and one type of batteriesUnit played fine with ac adapter. customer brought in hisebp and standard batteries (6). unit played with ebp using np-11 or acadapter. would not play with six (6) new batteries. the unit would onlyplay with ebp if batteries used were alkaline or rec
SONYKV1942R
Vertical roll and shrinkage at bottom, yoke wireWhen set was turned on picture would roll. if the verticalhold was adjusted picture would stabilize but picture was short a bottomabout 4 inches. after a couple minutes picture will roll again, adjusthold control and picture is normal.
SONYKX2501
Volume control changes picture level and r02 burnt, d1205Resistor r02 on u-1 board burnt. no video and volume controlwill affect picture level. checking from chassis ground to power supply12v ground the voltage was -11v. disconnected k1 and voltage remained.further checking found d1205 shorted and q1440 bad
SONYKPR41DS1
Dead, resoldered c-610Press power button and only sleep light will come on. no b+135v, or +/-18v. found positive side of c610 floating on board.