PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14168
Results: 14168
PHILIPS Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS | 43PFG5000/78 | No image, just lights up the LEDs | C216 na regua do display | Replace c216 or check for another fault. | ELETRONICA AUDIO E VIDEO BIRIGUI-SP |
| PHILIPS | 20PT3336 | Turns on, the image appears and then turns off. | 47 by 250v electrolytic capacitor (c2564) | Replace. | Ferraz |
| PHILIPS | 29PT4643 | Burns transistor 7406 | Replace 6410 diode | Replace 6410 diode | jcgiantomaso |
| PHILIPS | FWM653/55 | Only the power LED lights up | Coil pos. l554 on the CD board | Eletronicaaeb | |
| PHILIPS | 21PT8467/78 | In the first few seconds it would turn on with colored stripes at the top of the screen, then the blue tube would open and finally it would turn off, setting up protection. | C2465 electrolytic capacitor of 10uf by 250v (replace with a 47uf otherwise it won't work. | Edfesom | |
| PHILIPS | 21PT5402 TE3.2E | Very low sound | C486 470mf16v shorted, is in front of ic 403 tda7057 | Replace c486 470mf16v | PAULO COSTA |
| PHILIPS | 29PT4640/78 | The TV turns on and then turns off, when the image appears, tsound is a flicker on the side of the image and turns off. | Cause capacitor c2455=47uf for 25 volts, with low capacity. Just change and celebrate. | Armando de Olímpia | |
| PHILIPS | FWM6500 | Does not turn on, just standby lights blinking | Lack of 5v usb m601 does not pass 5v | I made an m601 jumper and 5v turned it on | beto2828 |
| PHILIPS | FWM6500 | Reset as | Perform the reset, with the network cable disconnected, press and hold the aux.game + title+ keys. then turn on the device. The message s-v27 will appear on the display. press the album key |>| ; turn on the device; The message grid10 will appear on the display. | beto2828 | |
| PHILIPS | 32PHG4900 | Reset for inverted or no image defect | With the TV on, you type on the control, (062598+menu casinha+111) then just turn it on the control and it turns back on normally. | Do this procedure | beto2828 |
| PHILIPS | 42PFL3604 | Turns on normally, after 30 minutes to 1 hour of operation it turns off. | Possible loss of capacity of components c 526, c 528 and c 529. | Replace without measuring: c526, c528 and c529. | arock |
| PHILIPS | 42PFL4007 | Doesn't start | Ci hdmi shorted killing voltage | Replace the ci u501 | cleberlima rs |
| PHILIPS | FWM6000X | Does not turn on, on standby | CD mechanism out of time or belt broken | This device only turns on if the mechanism is good | presto |
| PHILIPS | 42PFL3007 | Nothing turns on, dead power supply on secondary | Ci of the power supply a6069 shorted usually shorts from pin 1 to 3 | Replace of ci stra6069 or a6069 | Toledo |
| PHILIPS | 42PFL3007 | Nothing turns on, dead power supply on secondary | Ci of the power supply a6069 shorted usually shorts from pin 1 to 3 | Replace of ci stra6069 or a6069 | Toledo |
| PHILIPS | 20PT3331 | I'm sound | Shorted transistor 7202 smd npn | After changing the TV with sound ok. | George Pontes |
| PHILIPS | FWM416 | Doesn't start at all | Cap 1000x25 c172 | Changing it, tsound's no point in measuring, I did it on mine, it was fine. thank you amastec | eletronica gonçalves |
| PHILIPS | 32PFL4707G | It turns on normally, sometimes it turns on and sometimes it doesn't, both on the control and manual | Regulator g1084-33 replace the 2 | Dj Velk | |
| PHILIPS | 42PFL3604 | LED blinks but does not turn on, sometimes it turns on and increases the volume to maximum | Less than 3v at the output of (u4) tsound was no point in changing capacitors. | Place a 10r resistor between the middle pin 5v and the one on the right 3v3, | alcindo ferreira |
| PHILIPS | 14PT3131 | TV doesn't turn on, LED is off | Shorted power supply in fet(6n60) | After changing it, place it with a reduced frame on the sides and turn it off, replace the photo coupler and c-2464 (47μF x 160v, the TV was ok. | geraldo de petrópolis |