PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14168
Results: 14168
PHILIPS Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS | 42PFL3604/78 | The backlight does not come on or it just blinks. | After saving this power supply board with the defective components, I set it up on the bench and the TV only blinked. | C802 of 0.47/1 60 with replaced color however the biggest villain was the trimpot rw977 of 10k replaced to megas. I'm just exchanging them and joy | Rômulo |
PHILIPS | HTS6120/55 | It doesn't turn on just STB. | Capacitor c929 at the power supply shorted. | Replace and run for the hug. | Marcos |
PHILIPS | 40PFL6605 | Hdmi inputs 1 and 2 with sound, but no image. | Perform factory settings. | Menu - settings - configuration - factory setting - yes. | Persio (TVCompany) |
PHILIPS | 43PFG5000 | Turns on the panel but no image, tsound is no point in changing the signal board or t-com, the defect is one of the ceramic capacitors on the panel driver board, just test that one of them is shorted, in my case it was c216 | Ceramic capacitor c216 | Replace c216 | eletronilo |
PHILIPS | 25PT5541/78 28PW6441/78 28PW6542/78 29PT5642/78 32PW6542/78 L04U | Vertical closed from the middle up. | Capacitor c2463 (100x50v). | Eletrônica R-Tec | |
PHILIPS | 40PFG4109 | Lamps on, no image, stand-by blinks when the remote is activated | CD 7 (screen board) broken and shorted | HP ELETRONICA | |
PHILIPS | 32PFL5332/78 | Nothing turns on, no stand-by, no blue light, nothing | Possible protection of the main board due to overvoltage. Tsound were actually two 680uf 35v 105ºC capacitors swollen on the inverter board. | The capacitors were replaced (pay attention to their working temperature) and the board was reset (press power, chan-, vol+ at the same time) and everything worked again. | Turbinex |
PHILIPS | 20PT | Doesn't start | It doesn't turn on, it makes a noise knock knock knock, tsound's no +b | Tocar c2447 471x2kv | CENTER SOM |
PHILIPS | 42PFL3403/78 | TV activates relay, LEDs and sound but does not turn on the screen | El43 broke the board | Mateus Meireles | |
PHILIPS | FWC270/19 | Doesn't start. | Cold solder on the rectifier bridge. | Resolder on the rectifier bridge pins. | I.G |
PHILIPS | 14PT3336/78 | When turned on, it worked for a few seconds and then turned off. | In my case, the base of the varicap was broken, the welds below the board | Once the welding was done, it was beautiful. | ELETRONICA SALES. NATAL RN |
PHILIPS | FX50X/78 | It doesn't turn on, the front LEDs only blink when you click on power | Smd diode on the main board with s8 marking next to the shorted flat connector | Just replace it with any fast diode used in a switching power supply. | davi.sls |
PHILIPS | 20PT4331/78R | TV does not turn on, normal power supply voltages, normal horizontal drive pulse | 12 volts are missing, check this voltage on r 3424 | Defect r 3445 open is on pin 8 of the fly back value of the same 1r | Eletrônica do Ricardo caeté mg |
PHILIPS | 21PT9467C/78 | Expanded image as if it had been folded and with a dark side stripe | 8v2 zener diode shorted in position zd301 | Replace and that's it | fabio |
PHILIPS | 29PT8457/78 | Turns on and off after a few minutes | Memoria eprom | Re-record or replace the same | Eletrônica JP SM |
PHILIPS | 29PT9467C | Cushion effect, | Check the coil l432 that connects to pin 9 of the fly back is oxidized | Ademar Videira SC | |
PHILIPS | 29PT9467C | Cushion effect | Check the coil l432 that comes out of pin 9 of the fly back (open oxidized on one of the terminals) | Eletronica Tv color Videira sc | |
PHILIPS | 14PT3131 | Burning the r9520 2k2 | Ci smd tea1506t shorted on pin 14 | Replacing the TV component was just a wire | Marcos paredão |
PHILIPS | 32PFL4707G/78 | TV turning off after a while using HDMI inputs, rear buttons not responding, after turning off in any situation you have to unplug it and turn it on again. | Regulator g1084 of u701, was causing all the problems mentioned, everything working perfectly. | WALTER | |
PHILIPS | 42PF7321/78 | Turns on and then turns off, the power supply LED flashes continuously | Electrolytic capacitor | C8057 (22µf/50v) direct replace | Eletro Center |