Philco TV Repair: Common Faults and Solutions.
Search: Philco
Results: 4741
Results: 4741
Philco Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILCO | PCS2976 | After starting but then turns off | Cap c730 4n7........ | clayton | |
| PHILCO | 1451 | It turns on (when cold) but if it turns off it won't turn on again | C 708 e c709 poliester | tyko | |
| PHILCO | PCM 2046 | LED blinking TV won't turn on | Transistor q901 short, capacitor c915 dry | Replaced components | filipak |
| PHILCO | TP-2054 | Shows the burnout of the vertical integrated | Change c 614 | This capacitor being shorted immediately burns the integrated | milton |
| PHILCO | TPF-2940 | Voltage +b with 10v led on and it doesn't work if you press the power key it makes a noise and it doesn't work | D-919 byv26 | Put a new one in it was great | samuel leite |
| PHILCO | PCM 1446 | Doesn't work | High power supply not working, I removed tsh and +b appeared, I changed tsh but the TV didn't work. capacitor c924 and c719 also defective | Replaced tsh and capacitors tv func ok | almirguarani |
| PHILCO | TP2054 | The standby LED keeps flashing and makes a noise trying to oscillate | Diode d908 | Replace d908 which is shorted | Eletrônica Som & Imagem |
| PHILCO | TPF29S4F | Closed horizontally, cushion effect | R-1701 of 10r open | ladmyr | |
| PHILCO | PCM1444 | Dead | R902(open) | To replace | JARBAS SANTOS |
| PHILCO | TP-2053 | High power supply, device takes time to work | 19 | Take it out and measure it if tsound is even a slight replace causing the defect. | C.SOM |
| PHILCO | TPF-2941 | Works and turns off after seconds | C805-47u/160volt's | jarbas santos | |
| TV PHILCO HITAUTEC | PCR 1447 | Burning r 707 | Fly back ruim ov2094/d1 oub321087879-01b | Marcone | |
| PHILCO HITACHI | PC 1442 | Has sound, screen opens and closes quickly | R 725 4r7 behind the fly back | Marcone | |
| PHILCO | TP2052 | Image takes a while to appear when you just turn it on | Bad screen potentiometer contact | Replace the fly back or try cleaning the potentiometer with wd 40 | Alessandro |
| PHILCO | PCM 1444 | Stand by LED on and does not arm the power supply | Q904 bc 546 with leak | pedro ironei jr | |
| PHILCO | PCM-2054 | Cup effect, no characters, does not act tx | Deflector coil | Replace and if necessary adjust the height and linearity | Adrian Chapadão |
| PHILCO | PCM2046 | It only has 30 volts wsound it should have 95 volts | Ic 901 str50103 | juci | |
| PHILCO | TP1453 | If channel 5 appears, fi filter (mf 201) | Fi (mf 201) | Eletroinfor | |
| PHILCO | TP2054 | League, but with a high screen and inclined vertical retrace lines. | R714 open, caused by short ceramic capac c803 on the rgb board. replace the two components. | MANTENOPOLIS | |
| PHILCO | PCS2976S | Burning vertical outlet | Replacement of capacitor c614 47n, and modify c606 47n with the 100x35volt electrolytic cap. plus replacement of tda8177f with stv9379fa. | Maybe the tda8177f was fake, I replaced about eight. | marcioaz |