Philco TV Repair: Common Faults and Solutions.
Search: Philco
Results: 4740
Results: 4740
Philco Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILCO | TV PH29 US A2 | Image closed from the middle up | Diode d401 open | Replace it with 1n 4007 diode | EXPEDITO |
PHILCO | TP 2920 | TV doesn't turn on, only stand by stays on | Power supply +b with +- 12 v only has a signal on the stnd by led when you press the channel + key | Memory data, rewrite epron and everything ok. | DEBIQUE |
PHILCO | 21P | Nothing turns on, normal power supply | Swapping memory for 24c08 worked normally | ||
PHILCO | TP20V56 | TV with primary power supply ok without voltage on secondary | Resistor r 917 abreto 2k2 can by 3k9 | Eletrônica Muller | |
PHILCO | TV PH14D | Does not connect 16v power supply | Cause: +b5vstb with short, most likely going to 01 remote receiver | klein | |
PHILCO | TV PH21M SS | TV works - image cropped at the top sometimes shows 3 RGB lines | R306 amended | Replace r306 220rx2w | EMERSON RIBEIRO |
PHILCO | TPF-2130 | +b of the secondary oscillating up and down and it doesn't work. | Remove the r-936 resistor, remove the collar from its terminals and the board and replace it in its place | Ademar Videira SC | |
PHILCO/BRITANIA | PH 29/US-A2 | Damaged or closed vertical. | Ci stv-9378 open, if it is not available, stv-9379 can be used directly | Ademar Videira SC | |
PHILCO/BRITANIA | PH 29/US-A2 | Cushion effect, | Change the resistors r-401 and r-402, both cost 100r each. They are next to the microswitch control cable connector. | Ademar Videira SC | |
PHILCO/BRITANIA | PH 29/US-A2 | Tsound is +b in primary, but not in secondary | Change the resistor r-552 100k and the r-554 150k, both are next to the power supply trim-pot. | Ademar Videira SC | |
PHILCO | PCS-3300 | Transistor buk 438 shorted. | After making several contacts to obtain the same, none of the suppliers had it. | Solution, it was successfully replaced by the sth 12n60fi which is used in the Philips TV power supply model 29gx 1898 | Ademar Videira SC |
PHILCO | PH21 SS | Bluish image with retrace lines | D207 with short | Barter it | Marcondes Lima, Ohm Eletronica |
PHILCO | PC2043 CPH-05 | It turns on and off by itself, tsound is no on screen | Resistor de 100k(r713) | Eletronica Lelo | |
PHILCO | PCS-2952 | Open fuse | After surveying the entire power supply sector, we found all the diodes shorted, the fet shorted, the resistor r-945 open and the ci tda 4605 shorted. | Just replace the components above and go for the hug. | Ademar Videira SC |
PHILCO | TV PH 29 M | TV screams like i i i i i i i i i..... and voltages fluctuate secondary power supply | Fly back pifado. the Lord bless you Jesus loves you Jesus sets you free | Darci ivoti rs | |
PHILCO | PH21USA1 | Black stripes, vertical heating. | Replace c404 and dv401 with a 1n4007. | Toninho Pacheco | |
PHILCO | TVPH29B | The TV turns on, the image is missing, the sound is missing, after a while the sound becomes hoarse until it returns to normal. | Capacitors positions c-827, 1000 uf x 25 v. and c-833, 1000 uf x 16 v. | Replace them and go for a hug. | TALL-TEC Eletronica Rio Branco MT. |
PHILCO | TP1454 TP | Digital sound electronics nova timboteua pa | This TV started but did not oscillate +b with normal voltage. | It was the t702 oscillation drive that was open. and tsoundfore did not waver. t702 | |
PHILCO | PH21 US A1 | Lack of linearity at the bottom of the screen | Capacitor 562 ( 1000uf/25v) | Replace the same | BARRETO CRUZ |
PHILCO | TV PH 21C | It doesn't turn on, sometimes it turns on unexpectedly, sometimes with retrace lines at the top of the screen. | 82Ω resistor r881a open, q881 altered or shorted, causing 82Ω r881a to open. q881 is a 2n5551. | Swap the components and that's it! obs. q881 is a 2n5551 substitute; mpsa42... or 43. good luck! portaldaeletronica.forumeiros.com | Portaldaeletronica.forumeiros.com |