Philco TV Repair: Common Faults and Solutions.
Search: Philco
Results: 4740
Results: 4740
Philco Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILCO | PCS-2952N | Blinking led | C711 sem capacitance | ||
PHILCO | 14PHD | Philco ph14d tv by varicape with image without sound av with sound | Mormal image without sound via external antenna | Swap memory | patricio |
PHILCO | TV PH14C | Doesn't start | C438 shorted | Replace the same | jk eletrica |
PHILCO | TPS-2064 | Dead power supply | Resistor r 911 open | Replace the same value 2.2m | TIAGO.ELETRO |
PHILCO | PCS-2976S | Does not start, LED is off | Smd 936 | robson | |
PHILCO | TPF2940 | Standby LED flashing, the TV does not oscillate and goes out. | It was the two capacitors c1701 and c 1703=5k6 with low capacitance, I replaced them and the TV worked normally. | ELETRÔNICA MELO BOA VIAGEM -CEARA | |
PHILCO | PCM2051 | Takes time to call | Change c708 and 709 | joosias | |
PHILCO | PH21MSS | Cushion effect image stretched to one side | Diodo 454 (d454) proximo ao fly back | Bruno nicacio | |
PHILCO | TP-2052 | Does not turn on stantbay led blinking and with +b voltage varying @@@ | C913=1ufx100v | Help yourself leave your tip | ELETRONICA ARNI / L. LEAL-SC |
PHILCO | TPF2121F | Remote doesn't work | Leak between the sensor terminals, change it, or, in my case, scrape off the epoxy a little between the terminals and also between the contacts and the ground and also change the two 10 uf capacitors that are connected to it | ||
PHILCO | TP1453 | Vertical a little closed | Service mode | Adjust | Mauro Mascarenha - Parazinho Ceara |
PHILCO | PCM2046 | Turns off after a while. | Ic701 e c720. | R-TEC Eletrônica | |
PHILCO | PHILCO PH21B | Tsound are 2 defects, 1 turns on after 1 min + or - darkens and turns off 2 closes a little horizontally with retraction | V502 ou o c2383 | MARCIORV | |
PHILCO | TV-PH21C | Low power supply, LED does not turn on | Q881 changed | JOELTON | |
PHILCO | PH21M SS | TV inoperative and led pool | Change from-811 to-813(byv95) dz18v in the line of r818 q-802 and r826 | samuel leite | |
PHILCO | TPF2121C | TV turns on with sound popping and no image and turns off | R910 and r912 open | Just replace and run for the hug | Junio kleber |
PHILCO | PH21 MSS | Does not leave st. by. Because of a memory problem, I posted this defect and forgot to say that if anyone needs the eeprom, ask me by email: This email address is being protected from spambots. You need JavaScript enabled to view it. and I'll send it, ok? | Memory swap | reinaldo almeida | |
PHILCO | PH29M SS | Low power supply around 40v LED goes out but the TV doesn't turn on the power supply stays the same | C851 .1 with leakage is at the base of q808 | Replace c 851 | Damião |
PHILCO | TV PH21MSS | Does not leave st. by. | Memory, but be careful, I had already installed another one that I recorded with files downloaded from the internet and it didn't work, it only worked when luckily another TV like it came on and I copied the files and switched to the one that had the problem. | reinaldo almeida | |
PHILCO | PH21M SS | When turning it on, the LED flashes, +b changing to 24v | D818 =fr104 shorted | Replace it and run for the hug | hipereletronica service (maraial-PE) Marcelo |